755223
10
Zoom out
Zoom in
Previous page
1/38
Next page
10
Important: The maximum distance to the furthest extension
must not exceed 1 km.
Important: The voltage supply on the operating panels
must not fall below 10.5V DC (recommendation: min. 12V).
If the voltage is too low, duplicate the voltage leads with
remaining cables or use an additional voltage supply.
Before connecting the radio extension, make sure than the
alarm centre is disconnected from the power supply. The
first extension to the bus is connected to the alarm centre
via the NODE NETWORK IN connector (bus input). Each
successive extension is connected to NODE NETWORK
OUT (bus output) of the previous extension.
8.) Bus output
9.) Address of the extension
Set the jumper on the right position of the extension
module. Please ake care of using different adresses for
different extension modules.
10.) Learn sensor
11.) Radio module
12.) Tamper contact
13.) Jumper tamper contact
4. Programming
4.1 Setting learn mode
To put the extension module in learn mode, connect the 12 V
DC voltage supply (from the bus or a separate voltage supply).
When all sensors have been trained in the radio extension, they
are permanently stored, even if the power supply is removed.
When the voltage supply is first connected, the display shows
“88” and a short double signal sounds.
To enter learn mode, open the tamper contact (remove the front
panel) and then press “SELECT”. The display now shows “--”.
The module is now in learn mode.
Important: Before disconnecting the power supply, exit learn
mode of the extension module so that you do not lose the
trained devices.
4.2 Training radio components
1. Put the extension module in learn mode.
2. Make sure that the LED of the radio component to be
instructed is pointing to the learn sensor at a maximum
distance of 10 cm.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus Terxon LX - AZ4220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus Terxon LX - AZ4220 in the language / languages: English, German, Dutch, Danish, French, Italian as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info