756184

Abus fusg50000 Manual

7
Zoom out
Zoom in
Previous page
1/29
Next page
7
Device diagram
1 Wall plate 2 Piezo emitter
3 Jumpers 4 Mainboard
5 Battery connection 6 Cover tamper contact
7 Battery pack 8 Spirit level
9 Housing screws 10 Cover
11 Housing screw holder 12 Wall break contact
13 Lens 14 Flashing LED bar
Installation
Using the wireless testing box, determine a suitable location for the wireless external siren. Make sure that the siren is
mounted out of arm's reach (at least 3 metres above ground level). The siren should also be visible and audible from a
long distance.
In order to guarantee problem-free operation, the siren must NOT be mounted in the following locations:
Next to large metal structures (e.g. metal doors and frames, water tanks, vehicles and refrigerators).
Next to the main power, water or gas lines.
Within a metallic housing.
Next to electronic devices, especially computers, photocopiers and radios.
Opening the housing and inserting the batteries
1. Remove the covers on the two housing screws. Loosen the screws until the siren can be opened.
2. Hinge the cover to the side and remove it.
3. Insert both alkaline battery packs from the side into the battery holders. Use the attached clip to feed the battery
cable.
4. Connect the battery cable to the connections on the siren mainboard, paying attention to the correct polarity.
Incorrect polarity can damage the battery or the siren.
5. When replacing the battery, first remove the cable from the connection on the mainboard. Pull the cable through
the clip. Press the movable part of the battery holder downwards and remove the battery packs.
Pre-drilled holes for wall assembly are found on all four corners of the siren wall plate. Only use the enclosed screws
and wall plugs for assembly. The built-in spirit level above the battery compartment facilitates the alignment of the
siren. The length of the wall tamper contact can be set individually. This is made by trimming the pin.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus fusg50000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus fusg50000 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info