692290
38
Zoom out
Zoom in
Previous page
1/150
Next page
Installation and start-up
EN 13
The "Permanent Status LEDs", "Permanent Key Lighting" and "Info and Alarm Tone
Sounds on the control panel" functions are only available during operation with an
external power supply.
For the "Info and Alarm Tone Sounds on the Control Panel" and "Permanent Status
LEDs" functions, "Broadcast Panel Status" must be activated on the alarm control
panel.
For the "Info and Alarm Tone Sounds on the Control Panel” function, the
"Permanent Status LEDs" function must also be switched to ON.
In order to use the chip key function, we recommend using an external 12 V power
supply. Although the use of this function is possible without an external power supply,
this will make chip key recognition slower and will shorten the wireless control panel’s
battery life.
If you would like to change the operating mode of the control panel using DIP
switch eight and two, you will need to first wipe the control panel from the Secvest
and then teach it in again.
Changes via other DIP switches should be made only when the device is not
connected to a power source and the tampering switch is open.
Start-up
7. Insert the three AA alkaline batteries in the
battery compartment.
Make sure the polarity is correct!
As a rule, if it is possible, an external power
supply should be used. In this case, the
batteries act as a reserve power supply. If an
external power supply is not possible, the
control panel can also be used with certain
concessions in battery mode. The actual
battery life is, in this case, largely dependant
on the functions being carried out (Prox
reader, key pad lighting)
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus FUBE50001 - Secvest at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus FUBE50001 - Secvest in the language / languages: German as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info