692290
37
Zoom out
Zoom in
Previous page
1/150
Next page
Installation and start-up
12 EN
DIP switch layout
6. Adjust the DIP switch as required.
Factory/defa
ult setting*
Role
OFF
ON
1
STATUS LED
Permanent status LEDs
The status of the sub-
areas is only displayed for
a few seconds during
operation*
Permanent status LEDs
2
BACK COMP
Backward compatibility
FUAA50xxx*
All versions of firmware
Works in same way as
FUBE50000 (without
rolling code)
FU80xx
Works in same way as
FU8110
3
BATT MODE
Battery operation
Power supply unit
operation
(incl. batteries)*
Battery operation
(without power supply unit)
Suppresses the status
message "Ext. PSU error"
on the alarm control panel
4
INFO TONES
Info and alarm tone
sounds on the control
panel
No info or alarm tone
sounds on the control
panel*
Info and alarm tone
sounds on the control
panel*
5
KEY TONES
Keypad tones
Keypad tones deactivated*
Keypad tones activated*
6
PROX ENB
Chip key reader
Chip key reader
deactivated
Chip key reader activated*
7
KEY LED
Permanent keypad
lighting
Keypad lighting during
operation only*
(times out after 15
seconds)
Permanent keypad lighting
8
NU
Rolling code
WITHOUT
Rolling code
Compatibility as per DIP-
2
WITH
rolling code*
Compatible with Secvest
FUAA50xxx firmware
>=v2.00.03
DIP-2 without effect
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus FUBE50001 - Secvest at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus FUBE50001 - Secvest in the language / languages: German as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info