580000
5
Zoom out
Zoom in
Previous page
1/12
Next page
Preface
Dear Customer,
Thank you for purchasing this photo-electric radio
smoke detector. You made the right decision in choo-
sing this state-of-the-art technology, which complies
with the current standards of domestic and European
regulations. The CE has been proven and all related
certicationsareavailablefromthemanufacturer
upon request. To maintain this status and to guaran-
tee safe operation, it is your obligation to observe
these operating instructions! In the event of questions,
please contact your local specialist dealer. The radio
smoke detector reacts to visible smoke particles. If
too much smoke reaches its measuring chamber,
an alarm is triggered (direct on the detector and on
the alarm centre). If integrated into the ABUS radio
alarm system, the radio smoke detector occupies a
zone that is monitored even if the system is inactive.
The radio smoke detector is used in locations with
lowdustpollution(residentialbuildings,ofces)or
where thick smoke can be expected in the event of a
re(suchassmoulderingfurniture).
Read carefully the notes and advice in these opera-
ting instructions! If you do not follow these instruc-
tions, your guarantee claim becomes invalid! We can
accept no liability for the consequences! No part of
theproductmaybechangedormodiedinanyway.
Important
Smokedetectorscannotbeusedtopreventre.They
areusedmerelytoreacttospecicrecharacteris
-
tics. During installation, make sure that the detector
isplacedinaccordancewithlocalreprecaution
regulations and recommendations. These regulations
can vary from country to country. For more detailed
information,contactyourlocalreauthorities.
Selecting the installation location
Place the smoke detector directly on the ceiling in
the centre of the room. The minimum distance to
each side wall should be 12 cm. We recommend a
separate smoke detector for each entrance area,
staircase, living-room and bedroom. The distance
between two smoke detectors should not exceed 8
metres. Install smoke detectors in a position with the
best available transmission and reception properties.
Usedouble-sidedadhesivetapetoxthedetec
-
tor temporarily in different locations and test it by
triggering an alarm. If it is not detected by the alarm
centre, move the detector to a new position.
Do NOT install the detector:
– Places with greater temperature variation than the
ambient operating temperature range
– Places where draughts can keep smoke away
from the detector (such as near windows, doors or
ventilation shafts)
– Places with steam, high air humidity or exhaust
gases (kitchen, bathroom, garage, loft)
– Places where thick dust or smoke could impair the
function of the smoke detector.
At the highest point of a gable roof. The distance to
the rooftop should be at least 30cm.
– Near large metal structures
Installation
1. Important: Do not insert batteries until you train
the detector.
2. Remove the locking pin securing the mounting
bracket to the unit.
3. Remove the detector from the detector base. Do
this by turning the base anticlockwise.
4. Install the smoke detector at the selected location.
Screw the detector base to the ceiling.
a. Use the base to mark drill-hole positions. Use
the existing blanks.
b.Usescrewsandwallplugstoxthedetectorbase.
5.Makesurethatthedetectorbaseliesatontheceiling.
6. Open the battery housing and place the two lithi
-
um batteries provided in the battery clip. Check for
correct battery polarity.
7. Fix the sensor to the detector base and turn it
clockwisetoxitintoplace.Thedetectorhasa
safety device that prevents installation without a
battery.
8. Insert the locking pin in order to secure the moun
-
ting bracket to the detector. Test the alarm.
Learning
Tousethedetector,yoursthavetotrainitonthe
ABUS radio alarm centre. Proceed as follows:
1. Switch the alarm centre to learn mode. You see
the message “Scanning for signal” on the display.
2. Write message is sent automatically, 10 seconds
after installing the batteries, or by pressing the
detector‘s tamper for a period of 3 seconds.
3. Check that the alarm system has recognised the
radio smoke detector.
4. Switch the alarm centre back to normal operating mode.
5. To repeat training, remove the batteries and
replace them after about 30 seconds.
UK
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus FU9035 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus FU9035 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info