Manual Abus CASA10010 (page 36 of 123) (English, German, Dutch, Danish, French)

554030

Zoom out

Zoom in

1/123

After deciding on the place of installation, open the housing of the

IP alarm module and first remove the PCBs from the rear side by

carefully bending the upper PCB holder upwards until the PCB can

be removed.

Using the rear housing side as a template, mark the fixing holes on

the wall. Fix the IP alarm module to the wall, but do not tighten the

screws yet.

Connect the IP alarm module to the 12 V power supply.

Replace the PCBs and tighten the screws.

Carry out the necessary programming (see point 6).

Following successful programming, the piezo signaller on the IP

alarm module beeps at short intervals. Replace the cover at this

point, then close the housing.

After around 5 seconds, the piezo signaller emits a double tone

and confirms the programming.

5. Programming: Wireless

Program the IP alarm module step-by-step as follows. Firstly,

connect the module to the power supply (12 V PSU). Then carry

out programming.

5.1 Starting programming

Proceed as follows to start programming:

4. Make sure that the cover contact is open.

The green power supply LED lights up (PSU).

5. Press SELECT.

LED number 1 also lights up blue.

6. You are now in programming mode.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Abus CASA10010 in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 1,32 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Abus CASA10010 Manual

Product: