643674
42
Zoom out
Zoom in
Previous page
1/118
Next page
42
AZWG10000
10.2.1.4 Receiving an SMS acknowledgement
With the SMS commands, you can get an acknowledgement by SMS that the
device has received the SMS command. To obtain this acknowledgement, enter “!”
after the installer code. If the command was successful, you get an SMS with “0”, if
unsuccessful, you get an SMS with “1”.
“Installer code” “!” “4-digit SMS command” “=” “data 1”
Example:
Setting the user code
Installer code = 0200; command = PWFM; new code = 4444.
0200!PWFM=4444
10.2.2 Parameters
Description of command Selection Default
RLMD: GSM operating mode
See also 8.1 General.
0: GSM Backup
1: GSM Only
2: GSM Main
0
RSST: GSM signal strength
Minimal GSM signal strength (RSSI
signal).
1: Low Signal
2: Average Signal
3: High Signal
2
PSLT: PSTN Loss Delay
Period before switching from PSTN
to the GSM network.
10-255 s 10 s
GSLT: GSM Loss Delay
Period before switching from GSM
network to PSTN.
1-255 min 4 min
MTDT: Network fault time
Period until an event that switches
an output is sent.
0-255 min 30 min
CLDG: Caller ID
Defines whether all or only existing
contacts can send SMS
commands.
0: Call ID deactivated
6: Call ID activated
0
ICDS: Block incoming calls
Defines whether incoming calls are
accepted or rejected.
0: Incoming voice call
enabled
1: Incoming voice call
disabled
0
PWFM: User code
For remote access by SMS
4 digits 1234
PWIN: Installer code
For remote access by PC or SMS
4 digits 0200
PINC: PIN code of SIM card
PIN code (if used) of SIM card
4-8 digits -
SYRT: Redials
Number of redials for voice
transmission
0-9 3
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus AZWG10000 GSM-Interface at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus AZWG10000 GSM-Interface in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info