541311

AAS Ultra Analog VA-2 Manual

53
Zoom out
Zoom in
Previous page
1/66
Next page
4.4 The Play View 53
and 4 (its maximum value), the notes played are transposed and played sequentially, over a range
of one or more octaves depending on the value of the Range parameter. The direction of the
transposition is set with the Span drop-down menu. This parameter can be adjusted to Low for
downwards transposition, to High for upwards transposition or wide for transposing both upwards
and downwards. Finally, the Order control sets the order in which the notes are played, therefore
determining the arpeggio pattern. When set to Forward, the notes are played from the lowest to the
highest. When set to Backward the notes are played from the highest to the lowest. In the two last
modes, Rock and Roll exclusive and Rock and Roll inclusive, the notes are played forward from the
lowest to the highest and then backward from the highest down to the lowest. When using the RnR
exclusive mode, the highest and the lowest notes are not repeated when switching direction but in
RnR inclusive mode these notes are repeated. Finally, in Chord mode, all the notes are played at
once.
Rhythmic Patterns
Rhythmic patterns can be added to the arpeggio pattern by using the 16-step Pattern display. Notes
are played as the step display is scanned and the corresponding step is selected (red button on).
Notes are played regularly when all the steps of the display are turned on and rhythmic patterns
are created by selecting only certain steps. The arrow button below each step is used to fix looping
points from which the rhythmic pattern starts being played again from the beginning.
Rate and Synchronization
The rate at which the arpeggiator pattern is scanned is set by the Rate knob of the Arpeggiator
module or can be synced to the master clock of the Clock module. The Rate knob is only effective
when the Sync control is set to off. When the Sync control is on, the rate (tempo) is fixed by the
master Clock module (see 4.4.1) or the host sequencer when its sync to host button is turned on.
The rhythmic value of each step is set using the Step parameter. Values can range between a quarter
note and a thirty-second note with binary and ternary beat division options. One can then fix the
metric of the pattern by setting the loop point of the step display appropriately.
Latch mode
The Arpeggiator module is toggled in latch mode by clicking the Latch button to its on position. In
this mode, the Arpeggiator keeps playing its pattern when the notes on the keyboard are released
and until a new chord is played.
… 53 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AAS Ultra Analog VA-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AAS Ultra Analog VA-2 in the language / languages: English as an attachment in your email.

The manual is 3,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info