541311

AAS Ultra Analog VA-2 Manual

30
Zoom out
Zoom in
Previous page
1/66
Next page
30 Parameters
Input Level
Output
Level
Asym1
Asym2
Asym3
+ Saturation Level (Sym1)
+ Saturation Threshold (Sym1)
− Saturation Threshold (Asym1)
− Saturation Level (Asym1)
Figure 15: Saturation curves of the resonant filters. For asymmetrical curves, the saturation level
and threshold are different for positive and negative values of the input level.
one to three for both symmetrical and asymmetrical saturation. These distortion algorithms range
from very low distortion (clean circuit) to very high distortion.
Slave Filter 2
The Filter 2 module can be enslaved to the Filter 1 module. This can be done by clicking the
Slave toggle switch on the Filter 2 module. In this mode, the frequency of the Filter 2 module
follows exactly that of the Filter 1 module. The Frequency knob on the Filter2 module is then used
to adjust the offset frequency between the Filter 1 and Filter 2 modules. When slaved, the cutoff
frequency of Filter 2 module follows exactly that of the Filter 1 module including the effects of the
modulation signals from the keyboard, LFO or envelope generator acting on the Filter 1 module.
Note that the modulation entries on the Filter 2 module are kept active so do not forget to disable
them in order to have the desired effect.
Signal routing to the filters
The filter mixers allow one to control how the signal from the different sources, the two oscillators
and the noise source, are routed to the filters.
The amount of signals received by the filters from the the VCO1 and VCO2 modules is ad-
justed by the Vco1 and Vco2 knobs. These control simply apply a gain factor to the signal received
from the oscillators. The gain is increased by turning the knobs clockwise from a value of zero
(-inf dB) to a factor of about 3 (10 dB). In the same way, the amount of signal from the noise
source is adjusted using the Noise gain knob.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AAS Ultra Analog VA-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AAS Ultra Analog VA-2 in the language / languages: English as an attachment in your email.

The manual is 3,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info