Manual AA-Drill 77350-1 (page 21 of 36) (English, German, Dutch, French)

621600

Zoom out

Zoom in

1/36

Drill chuck and arbor:

Slide small end of arbor into the chuck, place long end inside spindle, hold crank

table 5 inches from tip of spindle, open chuck completely, pull feed pinion down,

pressing the chuck against the table till arbor is secure.

Morse taper drill bits:

To use Morse taper bits, remove chuck and taper. To remove

taper and chuck, adjust stationary depth to 3 inches (see

depth instructions). Turn spindle manually lining up spindle

and quill key holes. Using key bar tap lightly until taper and

chuck fall out. Loosen half wing bolt and allow spindle

assembly to return to its original position.

Place tapered bit into the spindle hole, twisting and pushing

upward until bit is snug. Place a block of wood on the table and crank up table until

the tapered bit is firmly into the spindle.

Changing speeds:

Choose the proper speed for the drilling operation and the

type cutter or drill bit being used.

1. With the tool running unlock the speed control handle

(1) on the left of the drill press head assembly.

2. Move the lever to the front to decrease the speed and

rear to increase the speed.

3. When the indicator on the control handle (1) is in line

with the desired speed on the speed scale, lock the

speed control knob clockwise until tight.

Warning: the speed control handle should always be locked.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of AA-Drill 77350-1 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,05 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

AA-Drill 77350-1 Manual

Product: