503278
49
Zoom out
Zoom in
Previous page
1/64
Next page
Instruction manual TWI 35-130 G/TWI 45-190 G 49
Service shall be carried out at least once a year both on the gas side and on the
water side. The frequency of the maintenance depends, among other things, on
the water quality, the average number of operating hours per day and the set
water temperature.
Remark
Regular maintenance lengthens the life of the device. For determining
the correct maintenance frequency, it is advised to have the service and
maintenance engineer check the gas side and the water side of the device
three months after installation. The maintenance frequency can be determined
on the basis of this check.
Proceed as follows for testing the proper functioning of all components:
1. Maximally turn the thermostat counterclockwise.
2. Wait until the fan stops.
3. Turn the thermostat to its original position. Then draw off water to create a
heat demand.
4. Check if the heating cycle runs correctly (7.3 “Heating cycle of the device”).
5. Check the CO
2
-value and adjust this if necessary (3.11 “Check and adjust
the CO
2
-value”).
6. Check all parts of the ue gas discharge system for proper fastening.
7. Check the pressure difference of the pressure switch (see the table).
Clean the heat exchanger if the pressure difference is too low
(10.4.3 “Clean heat exchanger”).
Pressure difference of air pressure switch
8. Test the functioning of the expansion valve of the protected cold supply
setup. The water has to ow out in a forceful jet.
9. Test the functioning of the T&P valve (if applicable). The water has to ow
out in a forceful jet.
10. Check the discharge pipes of the expansion valve and remove any
present scale deposits.
11. Drain the device (see Drain).
10.1 Introduction
10.2 Prepare
maintenance
10 Maintenance
Device Measured pressure difference over air pressure switch
TWI 35-130 ≥ 730 Pa (NAT and LP)
TWI 45-190 ≥ 370 Pa (NAT) and ≥ 430 Pa (LP)
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith TWI 35-130 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith TWI 35-130 in the language / languages: English as an attachment in your email.

The manual is 2,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith TWI 35-130

A.O. Smith TWI 35-130 User Manual - German - 64 pages

A.O. Smith TWI 35-130 Usermanual and installation guide - Dutch - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info