503275
77
Zoom out
Zoom in
Previous page
1/126
Next page
Fig. SGS 28 to 60 - CO
2
adjustment (partial load)
IMD-1095cR0
Fig. SGS 80 to 120 - CO
2
adjustment (partial load)
IMD-1097bR0
Note
Turning to the left (anticlockwise) means more less (lower CO
2
level) and turning to the
right (clockwise) means more gas (higher CO
2
level).
Note
After conversion, you must check that the gas control valve is gastight.
Remove the CO
2
measurement probe from the measurement nipple of the flue gas
outlet pipe.
Put the cap back on the measurement nipple of the flue gas outlet pipe.
Shut off the gas supply.
Replace the covers.
7.9.5 Switching pressure measurement
To measure the switching pressure, proceed as follows:
Isolate the appliance from the power supply (see section 4.2.2).
Carefully remove the covers from the appliance.
The electrical section is now visible.
Remove the black caps from the measurement point of the pressure switch.
Connect the + of the pressure gauge to the H of the measurement point of the
pressure switch.
Connect the - of the pressure gauge to the L of the measurement point of the
pressure switch.
Zero the pressure gauge.
n
23.
24.
25.
26.
1.
2.
3.
4.
5.
6.
7.
0311753_SGS_28-120_II_UKUK_V2.0 , 2017-05-03 77
77


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith SGS 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith SGS 100 in the language / languages: English as an attachment in your email.

The manual is 5,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith SGS 100

A.O. Smith SGS 100 User Manual - German - 128 pages

A.O. Smith SGS 100 Usermanual and installation guide - Dutch - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info