813875
7
Zoom out
Zoom in
Previous page
1/14
Next page
Not Recommended Fuel
You should avoid burning billets of split logs with a humidity of over 20% as it can prevent the
applian- ce from achieving its declared technical specifications, and can reduce the heat output.
Burning softwood billets and high-resin wood in the appliance is not recommended, as they result in
heavy smoking and frequent cleaning of the appliance and chimney flue.
Prohibited Fuel
The following is not allowed to be burned in the heaters: minerals, e.g. coal, tropical wood (like
maho- gany), chemical products and fluids, (like oil, alcohol, petrol, and naphthalene),
laminated boards, or adhesive-bonded, impregnated or pressed wood chips and litter. If any
other fuel is allowed, it will be notified on the rating plate.
Avoid filling the hearth with wood fully, optimising the amount of fuel at one-third of the
combustion chamber’s capacity. Before you replenish the wood, wait until the flames have died
down; do not add wood onto too much heat. After you light the fire, make sure you replenish
the wood in the combu- stion chamber by putting fuel inside so that the chamber is filled in a
reasonable way for the intended burning time determined by the user, based on his/her
individual experience.
Close the door each time. After a long period of non-use, a lower output startup is recommended.
The installation of the heater must be carried out by a person who is sufficiently qualified to
conduct assembly and installation work of this kind. This is a prerequisite for safe fireplace
firebox use. The in- staller must confirm correct assembly and installation execution in the
guarantee certificate by signing and sealing it. Failure to comply with this requirement will void
all the Buyer’s warranty claims against the heater manufacturer.
PREPARATION FOR INSTALLATION
The heater is delivered in a ready-to-be-installed state. Remove the packaging and check the
appliance for completeness according to this Operation Manual. You should also ensure that
the following are operational
•The control of the air supply for the combustion chamber (ash trap);
•The correct functioning of closing the front door (hinges, handle);
•The flue and smoke pipe durability must have a fire-resistance rating of a min. of 1 hr;
•The heater may be installed only after the smoke-duct chimney-sweep report has been completed.
CONNECTION TO CHIMNEY STACK
A free-standing stove must be connected to an individual chimney flue.
The minimum chimney draughts for rated heat output [Pa]: the chimney-draught values
- Minimum draught: 6 ± 1 Pa
- Medium, recommended draught: 12 ± 2 Pa
- Maximum draught: 15 ± 2 Pa
The chimney must be air-tight and its walls without any obstacles. Clean it of any soot and
FUEL CHOICE
- the manufacturer recommends hardwood billets like beech, hornbeam, oak, alder, birch, ash,
etc., with billet or split log dimensions 30cm long and circumferences between 30 and 50cm,
and lignite briquettes.
- the humidity of the fuel wood for the appliance should not exceed 20%, which is
characteristic of wood seasoned 2 years after felling and stored under cover.
Recommended Fuel
FREESTANDING ASSEMBLY AND INSTALLATION
other dirt before connecting. The connection between the chimney and the appliance must be
air-tight, made of non-flammable materials, and protected against oxidation (e.g. enamel-steel
flue liner). If the chimney generates a poor draught, consider installing new ducts. It is also
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.Caminetti PANORAMA series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.Caminetti PANORAMA series in the language / languages: English as an attachment in your email.

The manual is 2.22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.Caminetti PANORAMA series

A.Caminetti PANORAMA series User Manual - German - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info