607187
2
Zoom out
Zoom in
Previous page
1/4
Next page
2/2
Copyright © 2015 ZyXEL Communications Corp. All Rights Reserved
“INFORMAZIONI AGLI UTENTI”
Ai sensi della Direttiva 2012/19/UE del Parlamento europeo e del Consiglio, del 4 luglio 2012, sui
rifiuti di apparecchiature elettriche ed elettroniche (RAEE)
Il simbolo del cassonetto barrato riportato sull’apparecchiatura o sulla sua confezione indica che il
prodotto alla fine della propria vita utile deve essere raccolto separatamente dagli altri rifiuti.
La raccolta differenziata della presente apparecchiatura giunta a fine vita è organizzata e gestita dal
produttore. L’utente che vorrà disfarsi della presente apparecchiatura dovrà quindi contattare il
produttore e seguire il sistema che questo ha adottato per consentire la raccolta separata
dell’apparecchiatura giunta a fine vita.
L’adeguata raccolta differenziata per l’avvio successivo dell’apparecchiatura dismessa al riciclaggio,
al trattamento e allo smaltimento ambientalmente compatibile contribuisce ad evitare possibili effetti
negativi sull’ambiente e sulla salute e favorisce il reimpiego e/o riciclo dei materiali di cui è composta
l’apparecchiatura.
Lo smaltimento abusivo del prodotto da parte del detentore comporta l’applicazione delle sanzioni
amministrative previste dalla normativa vigente.”
安全警告
為了您的安全,請先閱讀以下警告及指示:
請勿將此產品接近水、火焰或放置在高溫的環境。
避免設備接觸
任何液體 - 切勿讓設備接觸水、雨水、高濕度、污水腐蝕性的液體或其他水份。
灰塵及污物 - 切勿接觸灰塵、污物、沙土、食物或其他不合適的材料。
切勿重摔或撞擊設備,並勿使用不正確的電源變壓器。
若接上不正確的電源變壓器會有爆炸的風險。
請勿隨意更換產品內的電池。
如果更換不正確之電池型式,會有爆炸的風險,請依製造商說明書處理使用過之電池。
請將廢電池丟棄在適當的電器或電子設備回收處。
請勿將設備解體。
請勿阻礙設備的散熱孔,空氣對流不足將會造成設備損害。
請插在正確的電壓供給插座(如:北美/台灣電壓110V AC,歐洲是230V AC)。
假若電源變壓器或電源變壓器的纜線損壞,請從插座拔除,若您還繼續插電使用,會有觸電死亡的風
險。
請勿試圖修理電源變壓器或電源變壓器的纜線,若有毀損,請直接聯絡您購買的店家,購買一個新的
電源變壓器。
請勿將此設備安裝於室外,此設備僅適合放置於室內。
請勿隨一般垃圾丟棄。
Troubleshooting
If a power or Ethernet light does not come on, please check the
cable connections and make sure the PLA is turned on.
If the PLA is connected to an Ethernet switch or router, make
sure that the switch or router is working correctly.
If the HomePlug light does not turn on, it means you do not
have a Powerline connection. Make sure that the PLAs are on
the same power circuit. Test by connecting PLAs into nearby
outlets. Make sure that you do not have a power meter
between them.
To minimize interferance, move PLAs away from large electri-
cal devices such as refrigerators or air-conditioners and
devices which produce radio waves such as electrical insect-
killers.
When securing the Powerline network, make sure not to press
the RESET/ENCRYPT or ENCRYPT buttons on both PLAs for
more than 3 seconds. If the process fails, press the said
buttons on both PLAs for 5 to 8 seconds to disconnect, then try
to reconnect again.
See the User's Guide for more troubleshooting and for how to
use the ZyXEL PLA Series Configuration utility to manage all
PLAs on your Powerline network(s).
www.zyxel.com
Declaration of Conformity
We herewith declare that this declaration is issued under our sole responsibility
Product
1
000Mbps Powerline 2
-
-
Thru Ethernet Adapter
Model
PLA5256
MANUFACTURED
BY
AND TCF FILE LOCATED AT
Company
ZyXEL Communications Corporation
Address
1.No. 2, Gongye E. 9th Road, Hsinchu Science Park, Hsinchu, Taiwan, R.O.C.
2.No. 6, Innovation Road II, Hsinchu Science Park, Hsinchu, Taiwan, R.O.C.
3.Generatorvej 8D, 2860 Søborg, Denmark
complies with essential requirements of the following EU harmonization legislation and
in conformity with the following presumption of conformity
Essential requirements Presumption of conformity
Directive 2006/95/EC
(LVD)
EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013
Directive 2004/108/EC
(EMC)
EN50561-1:2013
EN 55022 : 2010+ AC : 2011
EN 61000-3-2:2006+A1:2009+A2: 2009
EN61000-3-3:2013
EN 55024:2010
EN 50412-2-1:2005
Directive 2011/65/EU
(RoHS)
EN 50581:2012
Directive 2009/125/EC
(ErP)
EN 50564:2011
ZyXEL Communications Corporation
2015-04-13
Date of issue
Richard Hsu
/
Senior Manager
Quality
Management
Division
(2 seconds)
Within...
2
Minutes
3
4
RESET/
ENCRYPT
(2 seconds)
Secure the Powerline connection. The PLAs must have an Ethernet connection to use the RESET/ENCRYPT button.
Connect the PLAs to power outlets on the same power
circuit throughout your home.
RESET/
ENCRYPT
ETHERN ET
ENCRYPT
RESET
ETHERN ET
ENCRYPT
RESET
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ZyXEL PLA5256 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ZyXEL PLA5256 in the language / languages: All languages as an attachment in your email.

The manual is 4,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ZyXEL PLA5256

ZyXEL PLA5256 User Manual - English - 63 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info