679708
58
Zoom out
Zoom in
Previous page
1/313
Next page
IES-1000 User’s Guide
Hardware Connections 6-13
Figure 6-13 Connecting the Power Cord to the IES-1000 and a Power Source
6.6 DC Power Model Power Connections
Use the following procedures to connect the IES-1000 to a power source after you have installed the IES-1000 in a
rack.
Refer to power supply requirements in the hardware specifications in the appendices and make
sure you are using an appropriate power source.
Observe the following before you start:
Refer to the Hardware Specifications appendix for the gauge of wire to use for the IES-1000 power
connections.
Keep the IES-1000 power switch in the off position until you come to procedure for turning on the power.
Keep the power supply switch in the off position until you come to procedure for turning on the power.
Use only power wires of the required diameter for connecting the IES-1000 to a power supply
(refer to the hardware specifications in the appendices for the required wire diameter).
The IES-1000 power connections are at the left end of the front panel of the IES-1000 chassis.
6.6.1 Procedure to Connect the Power
When installing the IES-1000 power wire, push the wire firmly into the terminal as deep as
possible and make sure that no exposed (bare) wire can be seen or touched.
Step 1. Connect one end of a power wire to the –48V power terminal on the front panel of your IES-1000 and
tighten the terminal screw.
Step 2. Connect the other end of the power wire to the –48V terminal on the power supply.
Step 3. Repeat the previous step for the terminal labeled RTN.
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ZyXEL IES-1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ZyXEL IES-1000 in the language / languages: English as an attachment in your email.

The manual is 5,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info