729915

ZyXEL AMG1001-T Series Manual

47
Zoom out
Zoom in
Previous page
1/183
Next page
Chapter 7 Internet Setup
AMG1001-T/AMG1011-T Series User’s Guide
47
Bridge Interface This field is only available when you select PPPoE LLC or PPPoE VC-Mux in the
Encapsulation field.
Use this field to enable or disable the bridge mode. Activate the bridge mode when your
ISP provides you with more than one IP address and you want the connected computers
to get individual IP address from ISP’s DHCP server directly.
Connection Setting
Connection Select Always On (Recommended) when you want your connection up all the time.
The AMG1001-T/AMG1011-T will try to bring up the connection automatically if it is
disconnected.
Select Connect On-Demand when you don't want the connection up all the time and
specify an idle time-out in minutes. The default setting is 0 minute, which means the
Internet session will not timeout.
Select Connect Manually to establish the connection only when you need it.
Note: Do not specify an always-on connection unless your telephone company offers flat-
rate service or you need a constant connection and the cost is of no concern.
TCP MSS Option The TCP Maximum Segment Size (MSS) defines the size of the largest packet allowed on
an interface or connection. Enter the TCP MSS in this field. In general, the TCP MSS is
1452.
IP Address
Get IP Address Select the type of IP address provided by your ISP. A static IP address is a fixed IP that
your ISP gives you. A dynamic IP address is not fixed; the ISP assigns you a different
one each time you connect to the Internet.
Static IP Address Type your ISP assigned IP address in the field.
IP Subnet Mask Enter a subnet mask in dotted decimal notation.
Gateway Specify a gateway IP address (supplied by your ISP).
NAT Use this field to enable or disable Network Address Translation (NAT).
Default Route Select Yes to direct traffic not listed in the routing table to the default gateway. Select
No to drop traffic not listed in the routing table.
TCP MTU Option The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed on
an interface or connection. Enter the MTU in this field.
Dynamic Route RIP (Routing Information Protocol) allows a router to exchange routing information with
other routers.
Select the RIP version from RIP1, RIP2-B and RIP2-M.
Direction Use this field to control how much routing information the AMG1001-T/AMG1011-T sends
and receives on the subnet.
Select the RIP direction from None, Both, IN Only and OUT Only.
Multicast Multicast packets are sent to a group of computers on the LAN and are an alternative to
unicast packets (packets sent to one computer) and broadcast packets (packets sent to
every computer).
IGMP is a network-layer protocol used to establish membership in a multicast group. The
AMG1001-T/AMG1011-T supports IGMP v1, IGMP v2 and IGMP v3. Select Disabled to
turn off the feature.
MAC Spoofing This field is only available when you select 1483 Bridged IP LLC or 1483 Bridged IP
VC-Mux in the Encapsulation field.
Select Enable to alter the MAC address that you entered below so that the PVCs on the
AMG1001-T/AMG1011-T can establish connections to the network.
Table 14 Interface Setup > Internet (PPPoA/PPPoE) (continued)
LABEL DESCRIPTION
… 47 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ZyXEL AMG1001-T Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ZyXEL AMG1001-T Series in the language / languages: English as an attachment in your email.

The manual is 5,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info