Manual ZTE Z-660G Whirl (page 43 of 48) (English)

596105

Zoom out

Zoom in

1/48

Radio Frequency (RF) Energy

This model phone meets the government’s requirements

for exposure to radio waves.

This phone is designed and manufactured not to exceed

the emission limits for exposure to radio frequency (RF)

energy set by the Federal Communications Commission

of the United States, Industry Canada of Canada.

During SAR testing, this device is set to transmit at its

highest certiﬁed power level in all tested frequency

bands , and placed in positions that simulate RF

exposure in usage against the head with no separation,

and near the body with the separation of 15 mm.

Although the SAR is determined at the highest certiﬁed

power level, the actual SAR level of the device while

operating can be well below the maximum value. This

is because the phone is designed to operate at multiple

power levels so as to use only the power required to

reach the network. In general, the closer you are to a

wireless base station antenna, the lower the power

output.

The exposure standard for wireless devices employs a

unit of measurement known as the Speciﬁc Absorption

Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg,

and 1.6W/kg by Industry Canada.

This device is compliance with SAR for general

population /uncontrolled exposure limits in ANSI/IEEE

C95.1-1992 and Canada RSS 102, and had been tested

in accordance with the measurement methods and

procedures speciﬁed in OET Bulletin 65 Supplement C,

and Canada RSS 102. This device has been tested, and

meets the FCC, IC RF exposure guidelines when tested

with the device directly contacted to the body.

The FCC has granted an Equipment Authorization for

this model phone with all reported SAR levels evaluated

as in compliance with the FCC RF exposure guidelines.

SAR information on this model phone is on ﬁle with the

FCC and can be found under the Display Grant section

of www.fcc.gov/oet/ea/fccid after searching on FCC ID:

Q78-Z660G.

For this device, the highest reported SAR value for

usage against the head is 1.23 W/kg, for usage near

the body is 1.19 W/kg.

While there may be differences between the SAR levels

of various phones and at various positions, they all

meet the government requirement.

SAR compliance for body-worn operation is based

on a separation distance of 15 mm between the unit

and the human body. Carry this device at least 15

mm away from your body to ensure RF exposure level

compliant or lower to the reported level. To support

body-worn operation, choose the belt clips or holsters,

which do not contain metallic components, to maintain

a separation of 15 mm between this device and the

your body.

RF exposure compliance with any body-worn accessory,

which contains metal, was not tested and certiﬁed, and

use such body-worn accessory should be avoided.

FCC Compliance

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.

CAUTION: Changes or modiﬁcations not expressly

approved by the manufacturer could void the user’s

authority to operate the equipment.

NOTE: This equipment has been tested and found

to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

CTIA

a) Do not disassemble or open crush, bend or deform,

puncture or shred.

b) Do not modify or remanufacture, attempt to insert

foreign objects into the battery, immerse or expose

to water or other liquids, expose to ﬁre, explosion or

other hazard.

c) Only use the battery for the system for which it is

speciﬁed

d) Only use the battery with a charging system that has

been qualiﬁed with the system per CTIA Certiﬁcation

Requirements for Battery System Compliance to IEEE

1725. Use of an unqualiﬁed battery or charger may

present a risk of ﬁre, explosion, leakage, or other

hazard.

e) Do not short circuit a battery or allow metallic

conductive objects to contact battery terminals.

f) Replace the battery only with another battery that

has been qualiﬁed with the system per this standard,

IEEE-Std-1725. Use of an unqualiﬁed battery may

present a risk of ﬁre, explosion, leakage or other

hazard.

Only authorized service providers shall replace

battery. (If the battery is non-user replaceable).

g) Promptly dispose of used batteries in accordance

with local regulations

h) Battery usage by children should be supervised.

i) Avoid dropping the phone or battery. If the phone or

battery is dropped, especially on a hard surface, and

the user suspects damage, take it to a service center

for inspection.

j) Improper battery use may result in a ﬁre, explosion

or other hazard.

For those host devices that utilize a USB port as a

charging source, the host device’s user manual shall

include a statement that the phone shall only be

connected to CTIA certiﬁed adapters, products that

For Your SafetyFor Your Safety

82 83

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of ZTE Z-660G Whirl in the language / languages: English as an attachment in your email.

The manual is 3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

ZTE Z-660G Whirl Manual

Product: