533764
88
Zoom out
Zoom in
Previous page
1/100
Next page
ZOOM H4
88
Troubleshooting
If there are problems during operation of the H4, check the following points first.
Problems during recording/
playback
No sound, or sound is very weak
Check the connections to your monitor
system, and the volume setting of the
system.
Check whether the volume level setting
of tracks 1 – 4 is appropriate.
Recorder stops during playback
When playback is carried out with a
track in recording standby condition, a
temporary file is created in the H4. If the
remaining capacity of the SD card is
low, the temporary file may use up all
the remaining space, causing playback
to stop. In such a case, cancel the
recording standby condition of the
track.
No sound from connected instrument,
or sound is very weak
Check input source settings (
p. 31,
48).
Check setting of [INPUT 1 GAIN],
[INPUT 2 GAIN], and [MIC GAIN]
switches (
p. 32).
Check whether recording level setting
is appropriate (
p. 31, 48).
If [INPUT 1]/[INPUT 2] jacks are used,
try raising output level of connected
instrument.
When the monitor function (
p. 51) is
off, the input signal can only be
monitored if a track is set to recording
standby or if the recorder is in the
recording standby condition.
Cannot record on a track
Verify that [REC] key and key for
recording target track are lit in red.
If a project is protected, recording is
not possible. Use another project or
turn protection off (
p. 58).
Verify that an SD card is inserted in the
slot.
Check whether the key-hold function is
enabled (
p. 79).
If the indication "Card Protected" is
shown on the display, the SD card is
write-protected. Slide the write-protect
switch to the non-protected position.
Cannot perform bounce
Verify that the level of tracks 1 – 4 is not
fully lowered.
Verify that there is sufficient free space
on the SD card.
Other problems
Cannot use effects
Check whether effect section is on. The
effect section is off by default in stereo
mode and in 4-track mode.
Cannot use tuner
Check whether the jack to which the
instrument is connected is selected as
input source.
Unit is not recognized when connected
to a computer via USB
Check whether the operating system of
the computer meets the requirements
listed on page 80.
To have the H4 recognized by the
computer, USB mode must first be
selected at the H4 (
p. 81).
H4_E.book 88 ページ 2006年9月1日 金曜日 午後7時56分
88


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zoom H4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zoom H4 in the language / languages: English as an attachment in your email.

The manual is 2,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zoom H4

Zoom H4 User Manual - German - 103 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info