629759
30
Zoom out
Zoom in
Previous page
1/37
Next page
Effect Types and Parameters
ZOOM B2.1u
30
MS
MONO SYN (Mono Synth)
This is a monophonic (single-note) bass synthesizer that detects the input signal pitch.
CABINET
oF, 1 – 3
VARI
s1 – s5, p1 –
p5, m1 – m5
DECAY
0 – 98, 1.0
Numeric settings select different cabinet
types.
Selects the waveform type and sound
variation. "s" produces a sawtooth wave,
"p" produces a square wave, and "m"
uses PWM (pulse width modulation).
Adjusts the rate of sound change.
ZNR/MIX
ZNR/MIX module
This module serves for reducing noise during playing pauses. The module also is used to
control the mixing balance of original sound and effect sound for the DRIVE/SYNTH
module, and the signal level after the module. The ZNR/MIX module cannot be turned off
with the foot switch. To disable ZNR, set the effect parameter value to "oF".
nr
ZNR (ZOOM Noise Reduction)
This is ZOOM's original noise reduction that suppresses noise in playing pauses without affecting the tonal
quality of the sound. Also allows adjusting the mixing balance and level of the DRIVE/SYNTH module.
ZNR
oF, Z0 – Z9
MIX BALANCE
0 – 98, 1.0
LEVEL
2 – 98, 1.0
Adjusts the ZNR sensitivity. For
maximum noise reduction, set the value
as high as possible without causing the
sound to cut in or decay unnaturally.
Adjusts the mixing balance
between the signal before input to
the DRIVE/SYNTH module and
the signal after passing the
module. Higher setting values
result in stronger WET sound.
When the DRIVE/SYNTH
module is set to Off, the
indication "oF" is shown.
Adjusts the signal level after passing the
DRIVE/SYNTH module. When the
DRIVE/SYNTH module is set to Off,
the indication "oF" is shown.
LO EQ
LO EQ module
This is an equalizer for the low frequency range. You can select either a 3-band equalizer
or parametric equalizer.
LE
LO EQ (Low EQ)
This is a 3-band equalizer that adjusts the frequency range below 450 Hz.
70Hz
±12
150Hz
±12
450Hz
±12
70 Hz, shelving type equalizer. 150 Hz, peaking type equalizer. 450 Hz, peaking type equalizer.
LP
LO PARAMETRIC EQ (Low Parametric EQ)
This is a parametric equalizer that adjusts the frequency range below 650 Hz.
TYPE
1, 2, SH
FREQUENCY
See Table 1
GAIN
±12
Selects the type of filter. "1" gives a
peaking type filter with narrow Q, "2"
gives a peaking type filter with wide Q,
and "SH" produces a shelving type LO
EQ.
Selects a frequency within the range of
100 - 650 Hz.
Adjusts the gain.
Table 1
Display Frequency Display Frequency
10 100Hz 50 500Hz
25 250Hz 65 650Hz
35 350Hz
MS
NR
LE
LP
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zoom B2.1u at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zoom B2.1u in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info