10
The ingredients were not completely frozen
or they were too soft for making Quick Pops™
(some types of ice cream, puddings and
yogurt may not work well). Try waiting longer
before removing the Quick Pop™, or use dif-
ferent ingredients.
The tip of the Quick Pop™ stayed in the
mold.
The pop stick was not fully inserted into the
mold cavity. Be sure the pop stick is fully
seated in the mold cavity BEFORE pouring
the juice.
The second batch of pops doesn’t freeze.
Multiple batches of Quick Pops™ are possible
if done in quick succession. Too much time
between batches will cause The Quick Pop™
Maker to defrost. It is also possible that
the temperature of your freezer is not cold
enough, or The Quick Pop™ Maker was not
completely frozen. Lower the temperature of
your freezer to 0˚F (-18˚C) or less, and let the
unit freeze for at least 24 hours.
The tabs on the stick will not sit properly in
the mold.
Make sure that the sticks are inserted
BEFORE POURING JUICE, and that there are
no other ingredients at the bottom of the
mold cavity (nuts, fruit etc.) If sticks are not
seated properly, the Quick Pops™ will not pull
out.
My finger is stuck to the cavity.
If your fingers are stuck to The Quick Pop™
Maker, run your fingers under warm water. Do
not touch the metal part of The Quick Pop™
Maker when it is frozen.
The Quick Pop™ Maker container is broken,
and the liquid inside is everywhere.
The refrigerant liquid is non-toxic, but do not
try to use The Quick Pop™ Maker any longer.
It should be discarded immediately.
I lost my Super Tool/pop stick/drip cup.
Visit www.zokuhome.com to order
replacement parts.
My stick broke while removing the pop.
It is possible to break the stick with the Super
Tool when used with excessive force. Visit
www.zokuhome.com to order replacement
parts.