Manual Zibro SRE835E (page 11 of 15) (English)

564104

Zoom out

Zoom in

1/15

L: A blinking indica-

tor light is a sign that

you need extra ventila-

tion.

K: When the FUEL indi-

cator has appeard, the

information display will

show the number of

minutes of fuel left in

the tank.

J: When the SAVE func-

tion is activated, the

heater will automatically

switch on or off in order

to remain within a speci-

fied temperature range.

Fuel filter

J THE CORRECT USE OF ‘SAVE’

The ‘SAVE’ function allows you to limit the temperature. When this function is activat-

ed, the heater will automatically switch off, when the room temperature exceeds the

set temperature by 3°C. Subsequently, when the room temperature has dropped again

to the set temperature, the heater will automatically switch on again.

Activate the ‘SAVE’ setting by pressing the appropriate Ƽ key. will display on the

information display (Fig. J). Switch off the function by pressing the SAVE key once again.

Without the ‘SAVE’ setting your heater will maintain the set temperature by

approximation as well, by adjusting its heating capacity. ‘SAVE’ is an economy

setting, which you can use when, for instance, you are not present in the room

or to keep it frost-free.

K THE ‘FUEL’ INDICATOR

When the FUEL indicator appears, it means that there is only fuel left for 10 more

minutes. The count-down of the remaining heating time can be seen in the infor-

mation display ¹ (Fig. K). Now you have two options:

̈ you remove the fuel tank and refill it outside the living room (section B) or

̈ you push the button EXTENSION ƾ. By pushing this button, the remaining

heating time will extend to 90 minutes. The heater will automatically switch

back to its lowest position. In the display the number 90 will appear, which

will decline to 10. At the arrival of 10, you will hear an alarm signal every two

minutes, warning you to refill the removable tank. If you do not react, the

heater will extinguish by itself. The heater will also sound a warning signal,

when it switches off. The fuel indicator will blink, while four lines (--:--)

are blinking in the information display. You can stop this by pressing the

button Ƹ once more.

Once the heater has used up all its fuel and extinguished, it will take some time,

after the refill, before the heater is completely ready for use again.

L THE ‘VENT’ INDICATOR

When there is insufficient ventilation in the room, an intermittent buzzer will

be heard (approximately once each 30 seconds) and the VENT indicator

will

be blinking. When this signal is given, ensure that the ventilation of the room is

improved (e.g. by opening a door or window a little more), to avoid that the heat-

er shuts off. When the ventilation of the room is improved, the VENT indicator and

buzzer will be deactivated. When there is still insufficient ventilation, the heater

shuts off automatically. When this occurs, e- 1 1 is displayed and the

indicator

is blinking and VENT indicator (

) is lit. After improving the ventilation of the

room (e.g. by opening a door or window a little more), the heater can be ignited

by pushing

again.

M MAINTENANCE

Switch off the heater and let it cool down, before you start any maintenance

work. Also disconnect the plug from the mains. Your Zibro needs hardly any main-

tenance. It is, however, important that you clean the air filter ᕨ and the vent filter

ᕩ with a vacuum cleaner and the grid ᕢ with a damp cloth, both on a weekly

basis. Remove the air filter cap occasionally (Fig. M) and clean it with soapy water.

Prior to reinstallation, make sure that the air filter cap has fully dried.

Regularly inspect the fuel filter as well:

Remove the removable tank ᕧ from the heater and remove the fuel filter

(Fig. N). Some drops may leak from the filter; keep a cloth at hand.

p052_061_SRE835E_uk.indd 59 28-06-12 11:22

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zibro SRE835E in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zibro SRE835E

Zibro SRE835E User Manual - German - 15 pages

Zibro SRE835E User Manual - Dutch - 15 pages

Zibro SRE835E User Manual - French - 17 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zibro SRE835E Manual

Product: