367898

Zibro r 419 c Manual

59
Zoom out
Zoom in
Previous page
1/103
Next page
I
RREGULAR FLAME AND/OR SOOT AND/OR SMELLS
̈ The combustion chamber ¿ has not been positioned correctly.
Use the handle ´ to put it level, until you can easily slide it slightly to the left
and to the right and the chamber is level.
̈ The flame height has not been adjusted properly.
S
ee Fig. P and the directions in Section D.
̈ You are using fuel which is past its ‘use by’ date.
Start every heating season with fresh fuel.
̈ You are using the incorrect type of fuel.
Refer to THE RIGHT FUEL (Section ’What you need to know in advance’).
̈ Dust has gathered in the lower part of the heater.
Contact your dealer.
̈ The wick heigt is not correct.
Contact your dealer.
THE HEATER SLOWLY EXTINGUISHES
̈ The removable tank is empty.
Refer to Section B.
̈ The lower reservoir is contaminated by water.
Contact your dealer.
̈ The wick has hardened on the upper side.
Burn the heater until all fuel is used (Section G). Use the right fuel.
̈ You are using fuel which is past its ‘use by’ date.
Start every heating season with fresh fuel.
THE HEATER REMAINS BURNING LOW
̈ Wick position too low.
Contact your dealer.
̈ Before you refilled the tank, the heater had burnt up almost all the fuel.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
̈ You are using the incorrect type of fuel.
Refer to THE RIGHT FUEL (Section ’What you need to know in advance’).
̈ The room is insufficiently ventilated.
Leave a window or a door wide open for a while.
THE HEATER BURNS TOO HIGH, THE FLAMES CANNOT BE ADJUSTED.
̈ You are using an incorrect, too volatile type of fuel.
Refer to THE RIGHT FUEL (Section ’What you need to know in advance’).
̈ Wick position too high.
Contact your dealer
.
G MAINTENANCE
Y
our heater needs hardly any maintenance. It is, however, important that you
remove dust and stains in time with a damp cloth, because otherwise these may
cause stains that are hard to remove. Under normal conditions, only three
components are subject to wear:
4
56
… 59 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zibro r 419 c at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zibro r 419 c in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info