650597
17
Zoom out
Zoom in
Previous page
1/168
Next page
!
4
5
MANUAL
A INSTALLING THE HEATER
1 Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
a manual fuel pump
a transportation cap
these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
2 Open the lid of the removable tank and remove the piece of cardboard.
3 Fill the removable tank as indicated in Section B.
4 The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not try to correct the situation by placing books or other
goods under the heater.
5 Insert the plug into the wall-socket (230 Volts - AC / 50 Hz) and set the
correct time using the adjustment keys (refer to Section C).
6 Your heater is now ready for use.
SET ALTITUDE
1
If the heater is used at a height of 800 m to 1300 m, use the altitude mode 1.
Push the altitude button with thin rod like a clip and plug into the outlet
simultaneously. Then “1 ” will be shown on the display.
2
If the heater is used at a height of 1300 m to 1900 m, use the altitude mode
2. After setting the altitude mode 1, push the altitude button with thin rod
and plug into the outlet simultaneouosly again. Then “2 ” will be shown on
the display.
3
Switch off the altitude mode by pressing the altitude button and into the
outlet simultaneously after setting altitude mode 2. Then “0” will be shown
on the display and “ ” will be disappeared.
NOTE: When the altitude mode 1 is set, the altitude mark “ ” is lit on the display.
When the altitude mode 2 is set, the altitude mark “ ” is blinking during
operation.
NOTE: In the event of power failure or disconnection of heater, the altitude setting
will remain.
Do not use the heater at a height of over 1900 meters.
SWITCH THE VOLUME
This heater can be switched the buzzer sound volume. The initial setting is in
High level.
1
Push the SAVE key and holding it down for more than 3 seconds, then the
buzzer sound volume is switched from High to Low.
2
Push the SAVE key and holding it down for more than 3 seconds again,
then the buzzer sound volume is switched from Low to High.
NOTE:
The volume level is Low and High only, but the alarm by safety device
sounds in High level.
NOTE:
When the heater has been unplugged or after a power failure, the volume
will be the initial setting High.
B
A
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zibro LC-400 Toyotomi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zibro LC-400 Toyotomi in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 6,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zibro LC-400 Toyotomi

Zibro LC-400 Toyotomi User Manual - Dutch - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info