728824
18
Zoom out
Zoom in
Previous page
1/168
Next page
!
4
6
F: When the 4-digit
stops blinking, the set-
ting has been locked to
the indicated value.
B FILLING FUEL
ill the removable tank in a suitable place since there can alays be some
spillage. ollo the procedure belo:
1
Make sure that the heater is switched off.
2
Open the upper lid and lift the removable tank out of the heater (ig. B).
Put don the removable tank (cap pointing upards, handle on floor) and
scre off the fuel cap (ig. C).
NOTE: Some drops may leak from the tank.
3
ill the removable tank using a fuel pump (refer to fuel pump operation
instructions.) Make sure that it is in a higher position than the removable tank
(ig. ). Insert the ribbed hose into the opening of the removable tank.
4
Check the removable tank fuel gauge hile filling the tank (ig. E). Stop
filling once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
5
Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
6
Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C SETTING THE CLOCK
It is only possible to set the correct time and day, when the heater is connected to
the mains and not burning. Use the adjustment keys to set the time and exten-
sion/day/set (eekly timer) to set the day.
irst press one of the three keys to sitch on the function (the 4-digit will start
blinking). Next, set the hours using the key ( hour) and the minutes using the
key ( min.) and the day using the key etension/day/set .
Press once to increase the value by one step. When you hold don the key, the
value ill continue going up, until you release the key again. After approimately
10 seconds the 4-digit ill stop blinking and the setting ill be locked (ig.). 5
minutes after switching off the heater, the information on the display will disap-
pear and the heater ill automatically sitch into the stand-by position.
When the heater has been unplugged for more than 30 minutes (or after a
power failure), the time and the day need to be set again.
E
empty
full
D WEEKLY TIMER
Here is an example on how the weekly timer can be programmed:
Maximum of 3 programs per day can be set.
Every day of the week can be programmed separately.
Minimum switching interval, 1 hour.
Minimum activation time, 1 hour.
Choice between manual and timer.
Settings are saved in the memory and remain saved without power supply.
Monday Tuesday Wednesday Thursday Friday Saturday Sunday
P1 ON 6:30 6:30 6:30 6:30 6:30 10:00 9:00
P1 OFF 8:45 8:45 8:45 8:45 8:45 23:00 23:00
P2 ON 12:00 15:00 18:00 12:00 12:00
P2 OFF 14:00 23:00 23:00 14:00 14:00
P3 ON 18:00 18:00 18:00
P3 OFF 23:00 23:00 23:00
C
D
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zibro LC 140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zibro LC 140 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 7,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info