460409

Zibro KRA 106 Manual

56
Zoom out
Zoom in
Previous page
1/89
Next page
̈ i
nsufficient ventilation (leave window or door ajar)
̈ wastage of the wick (contact your dealer or replace the wick,
refer to section M)
E SWITCHING OFF THE HEATER
Let the heater burn at its lowest setting (Fig. M) for approximately one minute.
Then slowly turn the wick adjuster knob
· counter-clockwise to its stop. The
flame will extinguish after a little while.
NOTE: For routine turn-off, DO NOT use the “Manual Shutoff” or activate the
“Automatic Extinguisher” by jarring the heater. These methods may cause
unwanted odour, soot and smoke. Only the wick adjuster knob should be used
for normal shutoff.
NOTE: In case of an emergency, switch off the heater by turning the safety
button
ᕡ counterclockwise (Fig. N).
F ADJUSTING THE WICK HEIGHT
After a period of time the combustion may no longer be high enough (Section D). In
that case you can adjust the wick height to improve the flame. To do this, the heater
must have been switched off. Follow the procedure below:
Release the automatic extinguisher by turning the safety button counterclock-
wise. (Fig. N).
Pull the wick adjuster knob
· off the heater, so the wick height
lock
Ƹ will be visible.
Take the plastic collar between your thumb and index finger and pull it out.
Turn the collar up one step, to either position 2 or 3 (Fig. O). Carefully push
the collar back, so the pin engages in the recess.
Carefully reinstall the wick adjuster knob
·. This can be done in one
way only - check the rear of the cap for the correct position.
If adjustment of the wick height does not have the required effect, let the
heater burn until all fuel has been used up (Section H).
If the flame height is still too low and the wick is set on position 3, then contact your
dealer,
or replace the wick, refer to section M.
If the flame gets too high after adjus-
ting (Fig. Q), the wick height lock should be placed one position lower again.
Otherwise smoke or soot may be caused.
4
3
2
1
4
55
☞☞ ☞
M
N
O
… 56 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zibro KRA 106 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zibro KRA 106 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info