460426

Zibro Kamin R 21E Manual

46
Zoom out
Zoom in
Previous page
1/79
Next page
☞
A
fter having ignited the heater, always check whether the combustion
chamber
¿ is level, by sliding it slightly to the left and the right by its handle ´
(Fig. E). This should be a smooth movement. If the combustion chamber is not
level, this will cause smoke and soot to develop.
D BURNING OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can check
whether the heater is burning well. Too high a flame may cause smoke and soot,
whereas too low a flame causes smells. The page opposite the folding page shows
the minimum and maximum permissible burning heights of the flame (Fig. Q).
If the flame remains low after the adjustment, the wick height must be
adjusted
(refer to Section F).
Burning that is too low may be caused by:
̈ insufficient fuel (fill the tank)
̈ poor fuel quality (contact your dealer)
̈ insufficient ventilation (put window or door ajar)
̈ wastage of the wick (contact your dealer or replace the wick,
refer to section M)
When there is insufficient ventilation in the room, an intermittent buzzer will be
heard and the VENT lamp (Yellow) will be lit. When this signal is given, ensure that
the ventilation of the room is improved (e.g. by opening a door or window a little
more) to avoid that the heater shuts off. When the ventilation of the room is
improved, the VENT lamp and buzzer will be deactivated. When there is still insuf-
ficient ventilation, the heater shuts off automatically. After improving the ventila-
tion of the room (e.g. by opening a door or window a little more), the heater can
be ignited again.
This heater is fitted with a safety system that ensures that it switches off if you
lift the exchange tank out of the heater. To switch the heater on again, put the
exchange tank back and follow the steps in
chapter C.
E SWITCHING OFF THE HEATER
Push the OFF-button ³. The flame will extinguish after a little while.
F ADJUSTING THE WICK HEIGHT (R21E)
After a period of time the combustion may no longer be high enough (Section D). In
that case you can adjust the wick height to improve the flame. To do this, the heater
must have been switched of
f. Follow the procedure below:
Push the OFF button
³ (Fig. L).
Pull the knurled wick adjustment knob
· off the heater, so the wick height
lock
¸ will be visible.
Take the plastic collar between your thumb and index finger and pull it out.
T
ur
n the collar up one step, to either position 2 or 3 (Fig. M). Car
efully push
the collar back, so the pin engages in the recess.
3
2
1
4
43
☞
E
☞
L
M
R
VENT.
… 46 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zibro Kamin R 21E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zibro Kamin R 21E in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info