657592
6
Zoom out
Zoom in
Previous page
1/26
Next page
EN
5
2
1
4
3
SIMPLY SYSTEM
TM
See Chapter 9 - Maintenance
4.2 SAFETY FEATURES
4.2.1. Mechanical safety features:
The safety pressure valve exit is placed on the bottom of the machine.
so that steam, in case of overpressure, comes out underneath the device
with no harm to persons. The working pressure in the boiler is 4.5 Bar and
the safety valve must open within a range of maximum +2 Bar. The valve
must allow for more steam to exit from the valve than the boiler can create
so that pressure decreases.
2 INCOLOY 800 heat coils, extremely resistant against high temperatures
and against limestone deposits.
Intake and outtake air for the vacuum motor are kept in separate directions
in order to keep the motor cooled.
4.2.2. Electric safety features:
The boiler has a pressure sensor which guarantees that the pressure is
always around 4.5 Bar.
It has a multi pin construction and by just inserting the plug, which has a
special sequence, the electricity will pass on to the commands
on to the hose, to the iron or any other electric accessory.
If the sequence is correct, a resistor in the commands responds within a
very small tolerance range that our accessory is connected to; no foreign
accessory or object will be recognized.
If these criteria are met, approximately 7 seconds pass (delay) prior to
freeing the electric circuit.
4.3 TECHNICAL DATA
Data plate characteristics
WARNING! Make sure the technical data on the data plate matches that of
your electricity mains.
Technical characteristics
Voltage: 230 V +/- 6% 50 Hz
Boiler power: 2100 W (1050+1050)W
Motor vacuum power: 1200W higher technology gives same power as
a 1600 W motor but: quieter, lower vibrations, lower energy consumption,
higher reliability and higher air volume.
Iron power: 850 W
Steam pressure: (450 kPa) 4.5 bar
Steam flow: 55 g/min
Max. steam temperature in the boiler: 148°C
Effective Air flow: 23.51 l/sec
Vacuum pressure: 2290 mm H
2
O (~ 22.4 kPa)
Time of heating: 2 min. approx after turning on the steam power, just a few
seconds with refill
Boiler volume: 0.8 litres
Boiler capacity: 0.4 litres
Recovery tank volume: 1.2 litres
Length of flexible tube: 2.0 m
Working reach: 8 m
Length of power lead: 5 m
Working noise: 71 db(A)
Safety features:
Service pressure switch: 2 ± 6 bar 0.3+/-0.15
Safety thermostat: 170 °C
Boiler safety valve: 6 bar +/- 0.5
Low voltage handle commands:5 Volt
Safety float
Heat insulation in extension tubes
Steam safety lock
Patented systems:
Spray System
TM
• Slalom System
TM
• Simply System
TM
Product code: PWC-700B
• Weight: 9,7 kg
• Size: 336x332x479 mm
Safety heat insulation extension tubes:
separate tubes for 1 steam and 2 vacuuming,
3 outer tube protects from burning and
isolates the electric part 4.
Downloaded from www.Manualslib.com manuals search engine
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zepter PWC-700 Tuttoluxo 6S cleanSy at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zepter PWC-700 Tuttoluxo 6S cleanSy in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info