Manual Zennio Z41 Pro Touch Panel (page 28 of 96) (English)

623342

Zoom out

Zoom in

1/96

Z41 Pro

http://www.zennio.com Tecnical Support: http://support.zennio.com

3.2.4 INTERNAL TEMPERATURE SENSOR

Figure 21 Internal Temperature Sensor (Main Configuration)

This screen permits configuring the internal temperature sensor of the device. Three

parameters are provided for this:

Sensor Calibration: permits setting a certain correction over the values

thrown by the internal temperature probe. This way, if the value of the

measurement is found to be slightly over (or below) the actual temperature

due to external factors, it is possible to set an adjustment between -5.0ºC and

5.0ºC (0.0ºC by default), in steps of 0.1ºC. The value set here may be

optionally changed, in runtime, from the Configuration page (see section 2.4).

Sending Period: cycle time (in tens of a second) for sending the value of the

measured temperature to the bus. This sending is made through the

[General] Internal temperature object (see section 3.1), enabled by default.

The permitted values are 0 to 100 tens of a second. The value “0” (set by

default) deactivates this sending to the bus.

Send with a Temperature Change: permits performing a specific sending of

the temperature value to the bus –through the [General] Internal

Temperature object– whenever an increase or decrease greater or equal

than a certain value is detected between two consecutive measurements, no

matter if a periodic sending has been enabled or not. Such value (unsigned)

must be entered here, in terms of tenths of a degree. To avoid having this

extra sending on temperature changes, simply leave the default value (“0”).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zennio Z41 Pro Touch Panel in the language / languages: English as an attachment in your email.

The manual is 2 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zennio Z41 Pro Touch Panel Manual

Product: