59
Road Types Used for Route Planning:
Type Description
Motorways You might need to avoid motorways when you are driving a slow car or you are towing
another vehicle.
Unpaved
roads
ZENEC Navigation Software excludes unpaved roads by default: unpaved roads can be
in a bad condition and usually you cannot reach the speed limit on them.
Toll roads By default ZENEC Navigation Software includes toll roads (pay roads where there is a
per-use charge) in the routes. If you disable toll roads, ZENEC Navigation Software
plans the best toll-free route.
Charge
roads
Charge roads are pay roads where you can purchase a pass or vignette to use the road
for a longer period of time. They can be enabled or disabled separately from toll roads.
Permit
needed
You might need a permit or permission from the owners to use certain roads or to enter
certain areas. ZENEC Navigation Software excludes these roads from the route
calculation by default.
Ferries
ZENEC Navigation Software includes ferries in a planned route by default. However, a
map does not necessarily contain information about the accessibility of temporary ferries.
You might also need to pay a fare on ferries.
Cross-
border
planning
In some cases the route calculated according to your other navigation and route
preferences would lead through another country. If you wish to always stay within the
same country, turn this option off.
Route Calculation Method types:
Option Description
Fast
Gives the quickest possible route if you can travel at or near the speed limit
on all roads. Usually the best selection for fast and normal cars.
Short
Gives a route that has the smallest total distance of all possible routes
between the route points. Usually practical for slow vehicles.
Economical
Combines the benefits of Fast and Short: ZENEC Navigation Software
calculates as if it were calculating the Fast route, but it takes other roads as
well to save fuel.
Easy
Results in a route with fewer turns. With this option, you can make ZENEC
Navigation Software to take, for example, the motorway instead of series of
smaller roads or streets.
4.5.4 Regional settings
These settings allow you to customise the application for your local language, measurement units,
time and date settings and formats, as well as to choose the voice guidance profile you prefer. Tap
the following buttons:
, , .
