68835
96
Zoom out
Zoom in
Previous page
1/104
Next page
96
DEVICE CONNECTIONS
NOTES OF CONNECTION
1. This unit is designed to be used in a vehicle with a 12V battery
and negative grounding. Before installing this unit to a vehicle, a
bus, or a truck, make sure the battery voltage is appropriate for
this unit to be used, otherwise, install a transformer or DC/DC
converter to convert the output voltage to 12V.
2. To avoid short circuit in the electrical system, ensure that the
negative battery cable is disconnected before installation.
3. To prevent short circuit in the wiring and damaging to this unit,
secure all wires with cable clamp or adhesive tape. Route the
wires in a secured way, out of heating place without touching
any moving parts such as gear shift, handbrake, and seat rails
to prevent the wiring insulation being melted/wore off.
4. Never pass the yellow power cord through the installation hole
into the engine compartment and connect to the car battery.
Otherwise, a high possibility of serious short circuit to the
electrical system can occur.
5. Replacing a new fuse with 10A rating when the old one is
broken, using no fuse or fuse with improper rating may cause
damage to this unit or even fires. If a proper fuse is installed
and electrical problems still occur, please contact with any
professional car shops for inquiry.
6. DO NOT connect other equipment to the car battery to avoid
battery overheating.
7. Please make sure all the wiring connections & the cables of
the speakers are well-insulated. Otherwise, this unit may be
damaged by short circuit.
8. If an external power amplifier is connected, please don‘t connect
P.CONT lead to the power lead of the external power amplifier,
otherwise, electric spark or other damage may be resulted.
9. Never ground the speaker output to prevent the damage to the
built-in power amplifier.
10. The minimum rating of the speakers connected to this unit is
50W with 4 to 8Ω impedance.
NOTE:
Please read the safety warnings before installing this unit.
96


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zenec ZE-MC5600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zenec ZE-MC5600 in the language / languages: English, German as an attachment in your email.

The manual is 4,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info