544681
3
Zoom out
Zoom in
Previous page
1/6
Next page
Das Fahrzeug ist mit einem Eigendi-
agnosegerät (DME) ausgestattet.
Um Fehlermeldungen zu vermeiden,
muss vor Montagebeginn
unbedingt der negative Pol der
Fahrzeugbatterie abgehängt werden.
Bevor Sie mit dem Ausbau des VW
Originalgerätes beginnen, bereiten
Sie bitte zuerst das ZENEC Gerät
für die Installation vor. Verbinden
Sie das im Lieferumfang enthaltene
Hauptanschlusskabel, wie im An-
schlussdiagramm abgebildet, mit
dem ZENEC Gerät. Verbinden Sie
nun den verbleibenden Stecker des
Hauptanschlusskabels mit dem
ebenfalls im Lieferumfang
enthaltenen CAN/Stalk Interface.
Tampering with the on-board
electrical system might cause error
codes to be stored in the DME.
To avoid this, disconnect the
GND wire of the negative battery
pole before you start with any
installation work.
Before you approach the removal
of the OE factory installed device,
start by preparing the ZENEC
device for mounting as follows:
Connect the main harness of the
set content to the ZENEC device
as shown in the wiring diagram.
Proceed to connect the appropriate
cable end of the main harness to
the CAN/Stalk interface.
1
M o n t a g e : Installation:
2
2
Hebeln Sie nun, von rechts
beginnend, vorsichtig den das
Radio umgebenden Plastikrahmen
aus seiner gesteckten Verankerung.
Für diesen Schritt benötigen Sie
ein entsprechendes Lösewerkzeug
zur Entfernung von Kunststoff-
Paneelen.
Remove the OE unit: Gently lift
the trim frame starting on the
right side of OE device, using a
plastic panel removal tool. For
successful completion of this step,
using an appropriate prying tool is
mandatory.
4
Lösen und entfernen Sie die vier
Torx-Schrauben (TX25) vom VW
Originalgerät.
Unscrew and remove the four Torx
Screws (TX25) of the original VW
radio.
1
3
Fahren Sie mit dem Lösewerkzeug
einmal gegen den Uhrzeigersinn um
den Plastikrahmen.
Der Plastikrahmen sollte sich nun
vollständig entfernen lassen.
Run the prying tool anticlockwise
around the trim frame, to release it
from the console.
The trim frame should come off of
the console completely.
3
4
5
5
Ziehen Sie das VW Originalgerät
nun vorsichtig aus dem
Einbauschacht. Stecken Sie
anschliessend alle Kabel
an der Geräterückseite aus.
Remove the original VW radio unit
by pulling it out of the mounting
slot. Detach all the cables from the
backside of the OE device.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zenec Z-E2015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zenec Z-E2015 in the language / languages: English, German as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zenec Z-E2015

Zenec Z-E2015 Additional guide - English - 1 pages

Zenec Z-E2015 User Manual - English - 100 pages

Zenec Z-E2015 Quick start guide - English - 13 pages

Zenec Z-E2015 User Manual - English - 39 pages

Zenec Z-E2015 Additional guide - German - 1 pages

Zenec Z-E2015 Quick start guide - German - 14 pages

Zenec Z-E2015 User Manual - German - 111 pages

Zenec Z-E2015 User Manual - German - 39 pages

Zenec Z-E2015 User Manual - Dutch - 109 pages

Zenec Z-E2015 User Manual - Dutch - 39 pages

Zenec Z-E2015 User Manual - French - 111 pages

Zenec Z-E2015 User Manual - French - 39 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info