729836
37
Zoom out
Zoom in
Previous page
1/40
Next page
72 Rev.B 73 Rev.B
DYNAMIC INDICATION OF SEAT HEAT
NOTE
All functions related to the air conditioning are only status indications.
The effective range of functions is depending on the vehicle manufacturer, vehicle type and
vehicle configuration. The ZENEC system supports all listed functions above. Differences from
this information, features or functions cannot be used for claims.
Seat heater
Indication of current seat heating level.
In addition to the digit, the seat heating level will be indicated in
three different colour gradations.
Setting
The seat heating level will be displayed in combination with a
digit.
Function Icon Display Information
Temperature
arrows
Indication of actual air flow:
Frontwindow – Center – Leg room
Temperature
Blue ca. LOW – 20.0 C
Yellow ca. 20.0 – 24.0 C
Red ca. 24.0 – HIGH
Ventilator setting
The digit shows the fan level.
Function Icon Operation
A/C profile N/A Open up the shortlist of the various climate profiles
REMOVAL WORK AND PREPARATION
INSTALLATION NOTES
NOTE
Make sure that all connectors at the rear of the ZENEC system have suffi cient room and are
not bent.
Connectors without a retaining mechanism must be additionally secured with insulating tape.
CAUTION
The installation of the ZENEC system should be carried out by an authorized installer. Specifi c
knowledge and tools are required to do the installation. Incorrect installation can cause damage
to the vehicle and the ZENEC system.
Correct functioning can only be guaranteed when you use the ZENEC original accessories
included in the kit or those optionally available. The ZENEC system and the original accessories
must under no circumstances be modifi ed or altered in any way. Inappropriate actions can
cause damage to the vehicle and the ZENEC system.
NOTE
The ZENEC E>GO CORE is equipped with an integrated DAB+ receiver. To make use of this
you will need a suitable DAB antenna mounted to the vehicle (not included in kit) that must be
connected to the ZENEC system.
If the target vehicle is already equipped with an original DAB antenna, it is still possible to use it
in combination with the ZENEC system.
Software updates to the ZENEC system are installed with an USB memory device. Therefore
when fi tting the system make sure that the USB connection of the ZENEC system will still be
accessible later (installation of USB extension cable or USB hub).
If you have questions or problems relating to the ZENEC system, please contact the dealer from
whom it was purchased.
NOTE
1. Remove the ignition key and keep it outside the car until the installation is finished.
2. Please wait for approx. 10 minutes until the CAN bus system is completely shut down,
before you start with the uninstallation of the original device.
3. Start with the uninstallation of the original device.
4. Please switch on the ignition only, when all installation steps are done and the ZENEC
system is completely mounted.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zenec E-GO Core Infotainer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zenec E-GO Core Infotainer in the language / languages: English as an attachment in your email.

The manual is 18,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zenec E-GO Core Infotainer

Zenec E-GO Core Infotainer User Manual - German - 40 pages

Zenec E-GO Core Infotainer User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info