540045

Zelmer ZPG6134SZ Manual

28
Zoom out
Zoom in
Previous page
1/32
Next page
28
PG-006_v01
Troubleshooting
PROBLEM CAUSE TIP
No fl ame (ignitor does
not light gas)
Clogged fl ame holes
in the burner crown
Turn the burner knob to position ●
.
Close the gas valve and disconnect the appliance from the mains. ●
If necessary, ventilate the room. ●
Remove pan supports and external burner elements from the hob. ●
Clean them, paying special attention to the fl ame holes.
Dry all elements, replace them, connect the appliance to the mains ●
and open the gas valve.
Burner nozzle is
clogged
Turn the burner knob to position ●
.
Close the gas valve, disconnect the appliance from the mains. ●
If necessary, ventilate the room. ●
Remove pan supports and external burner elements from the hob. ●
Clean the nozzle or unclog it using a thin copper wire. ●
Replace all elements, connect the appliance to the mains and open ●
the gas valve. Try to light the burners again.
Do not use any coarse-grained abrasive agents, sharp
●
objects, wire sponges, powders and/or aggressive
chemicals for cleaning the hob and knobs.
Residues of food can best be removed by using
●
a wooden spatula or a special scrapper, while being
careful not to scratch the hob surface.
Molten sugar, aluminium and plastics should be removed
●
immediately (when warm) from the surface of the hob.
Sugar melts quickly on hot surfaces and may result in
permanent stains.
When cleaning, do not let water get under the hob.
●
Place dirty pan supports in warm water with a detergent,
●
then wash and dry them.
CLEANING THE BURNERS
In the case of food spillage, and periodically, remove tarnish
and dirt from the gas burners, ignitors and fl ame failure
safety devices.
Start cleaning burners by taking off the burner crowns and
the burner caps.
Put the burner crowns and caps in warm water with
●
a detergent, then wash and dry them.
Use a steel wire to unclog the holes in the burner crown.
●
After washing, check if the fl ame holes are clear.
Make sure that the burner base near the nozzles is
●
always kept clean. Dirty nozzles may cause clogging and
the burner’s fl ame will be weak, or will not light at all.
The nozzles should be cleaned by brushing them with
●
a brush soaked in a solvent.
Cleaned elements should be dried thoroughly, as wet
●
elements may prevent the gas from being ignited, or may
cause its incorrect burning.
Replace the dried elements, being careful not to damage
●
any of the ignitors or fl ame failure safety devices.
during cooking, always cover the dish with a lid. This ●
prevents excessive vapour from accumulating in the
room.
If you use cookware with diameter lower than
●
recommended, the fl ame will go around the sides of the
dish causing the handles to overheat and in some cases
to burn.
Overheated fats and oils may easily catch
fi re. Therefore, dishes prepared with fat or oil
should only be cooked under supervision.
In the case of power shortage, burners can be ignited
●
using a gas lighter or matches. Take extra care when
igniting burners with a gas lighter or matches.
Do not put a dish on two burners at the same time.
●
Use only clean, dry cookware with a height of approx.
●
2/3 of its diameter.
Never operate the hob with wet hands.
●
Never leave the appliance unattended with gas burners
●
turned on.
Cleaning and maintenance
Before proceeding with cleaning, disconnect
the hob from the power supply.
In order to look nice and work properly the hob should be
systematically cleaned.
Before cleaning, remove pan supports and external
●
burner elements from the hob.
Hob surface, enamelled surfaces and burner casings
●
should be cleaned using a damp cloth soaked in warm
water with a washing-up liquid. Avoid using too much
water.
Strong dirt may be removed using special detergents for
●
cleaning ceramic hobs and stainless steel.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer ZPG6134SZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer ZPG6134SZ in the language / languages: English, Polish as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info