539681

Zelmer Roto VC1001.0 SF Manual

34
Zoom out
Zoom in
Previous page
1/38
Next page
40 VC1001-001_v01
2
Press the on/off switch (4) to stop the vacuum cleaner.
Remove the plug of the cord from the socket.
3
Press both of the side buttons situated on the end of the
hose, and remove the end of the hose from the inlet of the
vacuum cleaner.
4
Release the fastening of the upper cover (6), and open it.
5
Close the opening of the bag by means of a stopper.
6
Bend back the bag handle in the direction of the vacuum
cleaner handle (7).
7
Grab the bag plate, pull it out of the handle, and then
remove the entire bag upwards.
8
The SAFBAG number is placed on a label situated in the
chamber of the vacuum cleaner.
9
Place the bag plate of a new bag into the guides of the
SAFBAG handle, and slide it to the limit. The direction in
which you should install the bag is marked by an arrow on
the bag.
10
Bend back the bag handle in the direction of the control
knob (4).
11
Close the cover by pressing it, until you hear
a characteristic “click” – be careful not to trap the bag.
DonotstartvacuumingwithouttheSAFBAG-
type bag. No SAFBAG-type bag makes it
impossible to lock the upper cover of the
vacuumcleaner.
Zelmer vacuum cleaners are equipped with SAFBAGtype
bags in the amount given in the table. You have to replace
the bag, if:
a) the full bag indicator is on,
b) the vacuum cleaner works less efciently,
c) the bag is full.
(De)installing the HEPA inlet lter and the
foam rubber
Before replacing the HEPA inlet lter and the foam rubber,
make sure the vacuum cleaner is turned off, and the plug of
the cord is out of the electrical socket.
INTAKE FILTER (HEPA)
The vacuum cleaners are equipped with a High Efciency
Particulate Air (HEPA) H11class inlet lter. A HEPA lter
is produced of special bers, capable to highefciency
ltration, stopping almost all particles larger than 0.3 μm.
H11 is a class which determines the permeability of the lter.
The H11class HEPA lter stops 95.5% of particles larger
than 0.3 μm.
1
Release the fastening of the upper cover (6), and open it.
2
Remove the SAFBAGtype bag (13) from the chamber of
the vacuum cleaner.
3
Pull out the HEPA intake (11) from the guides situated at
the back wall of the chamber of the vacuum cleaner.
4
Put the new lter into the guides situated at the back wall
of the chamber of the vacuum cleaner.
D
Alwaysreplace a damaged HEPA intake lter
(11)withabrandnew,originalone.TheHEPA
intakelterisguaranteedtomakethevacuum
cleanertoworkefcientlyforca.ayear.
5
Place the SAFBAGtype bag into the chamber of the
vacuum cleaner.
6
Close the cover by pressing it, until you hear
a characteristic “click”.
FOAM RUBBER COVER
1
Release the fastening of the upper cover (6), and open it.
2
Remove the foam rubber cover (12) from the three
fastenings of the upper cover.
3
Replace the old foam rubber cover with a new one (12)
in such a way that the three incisions on the foam rubber
cover nd the three fastenings of the upper cover.
Alwaysreplaceadamagedfoamrubbercover
(12)withabrandnew,originalone.
4
Close the cover by pressing it, until you hear
a characteristic “click.”
After-work procedures, cleaning and
maintenance
1
Press the on/off switch (4) to stop the vacuum cleaner.
2
Remove the plug of the cord from the socket.
3
Wind the cord by pressing the cord winder button (3).
Hold the cord when doing it to avoid tangling the cord up or
letting the plug hit the vacuum cleaner.
4
Disconnect the telescopic pipe from the nozzle or brush.
5
Disconnect the telescopic tube from the hose. In order to
remove the tube from the hose handle press the “A” locking
device and pull the tube in the direction of the arrow.
6
Press both of the side buttons situated on the end of the
hose, and remove the end of the hose from the inlet of the
vacuum cleaner.
7
The vacuum cleaner together with its attached
accessories may be stored in a vertical or horizontal position.
In order to this, place the hook of the nozzle brush into the
fastening for the nozzle brush. The hose may stay attached
to the vacuum cleaner as long as it is not bent too much
during storage.
8
If necessary, clean the casing and the chamber of the
vacuum cleaner with a damp cloth (it may be damped in
dishwashing liquid), dry it off, and wipe it dry.
Donotuseanyscrubbingagentsorsolvents.
E
F
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer Roto VC1001.0 SF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer Roto VC1001.0 SF in the language / languages: English, Polish as an attachment in your email.

The manual is 3,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info