538895
71
Zoom out
Zoom in
Previous page
1/76
Next page
71GW13-014_v02
Clean the rim of the lter holder (E) to
remove any excess coffee. This will ensure
that the lter holder (E) is properly xed in
the brew head.
Notice: Espresso requires coffee which has
been ground more nely than regular bean
coffee.
Place the lter holder (E) in the brew head
(slightly to the left).
Notice: projections on the holder (E) must t in
the slots of the brew head.
Turn the lter holder (E) all the way to the right.
Warning: Ensure that the lter holder (E) is
correctly xed in the brew head. If you are not
sure, do not operate the appliance, but remove
the lter holder (E) and replace it following the
procedure described above until it is properly
placed.
Place one or two cups under the two outlets
of the lter holder (E).
Turn the regulator knob (K) to the left into
position as soon as the standby pilot light
stops ashing and comes off (N). If the coffee
has been properly ground and tamped, then
obtaining espresso with the „crema” foam on top
should take no longer than about 30 seconds.
The standby light (N) is illuminated during this
process.
Turn the regulator knob (K) into position 0
again to nish the coffee brewing process.
Frothing milk
Ensure that the regulator knob (K) is in
position 0 and button is pushed in (M).
The turned off pilot light (N) indicates the
standby mode of the espresso machine.
Press the hot water/steam button (B) to
set the espresso machine in the steam mode
(position ).
Rinse the steam wand by placing a dish under
the steam wand (C) and turning the regulator
knob (K) into the steam position .
Turn off the steam by turning the regulator knob
(K) into position 0.
Fill up a stainless steel jug or cup with fresh
cold milk up to 1/3 or 1/2 of its capacity and
place the frothing attachment (D) onto the
steam wand (C).
Warning: THE METAL STEAM WAND MAY
BE HOT.
Lift the jug so that the steam wand is immersed
about 1/2 cm below the surface of the milk.
Warning: THE JUG/CUP WILL GET VERY HOT
DURING FROTHING.
Turn the regulator knob (K) into position
and regulate the steam ow (by immersing
the steam wand in milk nearer to or further
from its surface) to obtain the froth required.
Turn the regulator knob (K) into position 0 to
reduce the pressure until the volume of the milk
has doubled. The top part will be frothed milk
and the bottom part will be steamed milk.
Tip: Spoon the froth into cups with espresso
coffee. Add liquid milk. A cappuccino should be
1/3 of coffee, 1/3 of hot milk and 1/3 of froth.
71


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer Piano 13Z014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer Piano 13Z014 in the language / languages: English, Polish as an attachment in your email.

The manual is 4,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info