538963
38
Zoom out
Zoom in
Previous page
1/42
Next page
40 GW32-003_v02
Dear Customers,
Congratulations on your choice of our appliance, and
welcome among the users of Zelmer products.
In order to achieve best possible results we recommend
using exclusively original Zelmer accessories. They have
been specially designed for this product.
Please read these instructions carefully. Pay your special
attention to important safety instructions, in order to avoid
accidents during operation and/or avoid damage of the
appliance. Keep this Instruction for future reference.
Important safety instructions
Warning!
Risk of property damage
Connect the appliance to 230 V mains supply.
Do not unplug by pulling on cord.
The supplying cord shall not be hanged over the edge
of the table or board, nor touch any hot surface.
Do not ll the jug in with boiling liquids.
Keep the stand blender and supplying cord away from
hot surfaces and burners.
If it is possible, store the stand blender away from
direct sun radiation and glow-like light.
Never store with lid closed on the blender jug. Damp
the lid gasket with water before usage, and insert the
lid on the jug.
Do not overow the jug. In case the liquid gets under
the motor housing, it can be vacuumed into the motor,
causing its damage.
Do not ll the jug over 1250 ml mark in such case,
the content of the jug can lift the lid when the motor
starts up
It can be operated not longer than 3 minutes, without
interruption in constant or pulsating mode („Pulse” and
Ice Crush” features), otherwise it can get overheated.
After 3 minutes of operation, switch off the appliance
for at least 10 minutes, and let the motor cool down.
Do not operate when the jug is empty, as it can get
overheated.
Use the soft brush for washing metal parts, especially
the sharp blades.
Tip
Product information and tips on its use
Read the whole instruction for use before you start
using your stand blender.
The stand blender is intended for domestic usage only.
In case it is used for gastronomic business purposes,
warranty terms and conditions change.
EN
Danger! / Warning!
Risk of injury
Always place the appliance on at, plain surface.
Always unplug the appliance when it is not in use and
before cleaning.
Do not operate the appliance if the cord, the housing or
the handle is visibly damaged. In such a case, return
the appliance to a service center.
If the non-detachable part of the cord is damaged,
it should be replaced by the producer or at a proper
service point or by a qualied person in order to avoid
any hazards.
The appliance should be repaired by trained staff only.
Improper repair can result in serious hazard for a user.
In case of defects we recommend you to contact
qualied service desk.
Do not immerse motor housing in water or any other
liquid; do not use it in bathroom and outdoors.
Press „
Off” button, before you remove the lid of the jug
and remove the jug from the motor housing, wait until
the blades stop completely.
Do not use stand blender without feeder opening
stopper.
Do not put your hands inside the jug, even if it is
removed for cleaning, as the cutting blades are still
dangerous – very sharp.
Do not put any objects (spoon, etc.) into the jug, when
the blender is connected to power supply.
Do not wash the cutting blades directly with hand.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by
a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Make sure you understand well above mentioned
instructions.
Safety recommendations
The stand blender has thermal protection, which turns off
the device at the moment of overheating. In this case, it is
necessary to disconnect the device from the power source.
Remove the plug from the contact, then wait at least 10
minutes, allowing the motor to cool down. After this time, you
can re-attach the stand blender.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer 32Z010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer 32Z010 in the language / languages: English, Polish as an attachment in your email.

The manual is 2,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info