Manual Zelmer 04Z010 (page 44 of 46) (English, Polish)

538910

Zoom out

Zoom in

1/46

GW04-003_v03

The fryer complies with the requirements of the binding

norms.

The appliance complies with the requirements of the

directives:

Electrical low voltage appliance (LVD) – 2006/95/EC. –

Electromagnetic compatibility (EMC) – 2004/108/EC. –

The appliance is marked with an indication CE on the data

plate.

Parts Map (Fig. A)

Cover lid

Frying basket release button

Handle

“POWER” lamp

“TEMP.” lamp

Cover lid opening button

“Set” button – timer

Temperature control

Filter cover

Filter

Frying basket

Pot

Power supply cord storage compartment

Power supply cord and plug

Operation and use (Fig. B)

Put the appliance on a horizontal, even and stable

surface out of the reach of children.

Fill the fryer with oil, liquid fat or melted solid fat up to the

level between indication marks of MIN and MAX on the inner

part of the pot (12) based on gures presented in the below

table:

Capacity Liquid fat Solid fat

MIN

2.2 liters 1925 g

MAX

2.5 liters 2200 g

We advise you to use frying oil or other liquid fat. If you want

to use new blocks of fat, melt them slowly over a low heat

in a normal pan to prevent spattering or overheating of the

fat. It is possible to use solid fat, but in that case extra pre-

cautions are necessary to prevent the fat from spattering.

ATTENTION: Never mix two different kinds of oil or fat.

Close the lid (1) and put the plug in the wall socket.

The red “POWER” (4) indicator signalling connection of

the appliance to the electric power sup-ply becomes bright

simultaneously as well as the green “TEMP.” (5) indi-cator

signalling that the appliance is in heating up process.

Set the temperature control (8) to the correct temperature.

For informa-tion about which temperature to select, check

the chapter “Preparation times and temperature settings” in

this Use & Care Manual. The oil or fat will be heated to the

right temperature in 10 to 15 minutes.

While the fryer is working, the green indicator light (5) will go

on and off a number of times as a result of reaching the set

temperature. This is a normal state. When the appliance is

ready for frying (the set temperature has been reached), the

green indicator light will go off.

The same procedure applies if you want to fry a number of

batches in a row. Therefore, wait until the green indicator

light has gone off before you start frying the next batch.

Open the lid (1) pressing the release button (6).

Lift the handle (3) and the basket (11) will automatically

raise to its highest position.

Take the basket out of the fryer. Put the food to be fried

in the bas-ket. For the best frying results, we advise you to

use the recom-mended quantities of food as indicated in the

chapter “Preparation times and temperature settings” of this

Use & Care Manual.

ATTENTION: During frying, hot steamed is released

through the l-ter (10). Remember to keep your hands

and face at a safe distance from the lter. You should

also be careful of the hot steam when you open the

lid (1).

Carefully insert the basket (11) in the fryer and make

sure it is properly installed.

Next, close the lid (1).

Gently lift the handle (3), slide the release button (2) on

the basket handle (3) and carefully place the basket (11) in

the lowest position.

In order to set the required frying time (in minutes), press

the button „Set” (7) of a timer.

Method of using the timer button

Keep pressing the timer button

●

„Set” (7) for 1 second.

The display of the timer will show a gure <00>. The

display will turn off 5 seconds after the last pressing.

Keep pressing the button

●

„Set” (7) In order to set

the required time. The gure on the display increases

by 1 minute from <00> to <30>. When the time setting

reaches the Max. gure, further pressing of the button

„Set” (7) will again cause an increase of the gure

on the display from the beginning, i.e. from <00> to <30>

minutes.

2 seconds after setting the time, the display will begin to

●

ash and count down the time. During counting down the

dis-play show the gure indicating the remaining time of

frying. The last minute of frying is indicated in seconds.

Keeping pressing the button

●

„Set” (7) for over

2 seconds during counting down the time results in

stopping of counting down. The display will show a gure

<00>. Then, the timer may be set again. The display will

turn off and the appliance will switch over to stand-by

after about 5 seconds from the last pressing.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer 04Z010 in the language / languages: English, Polish as an attachment in your email.

The manual is 1,6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zelmer 04Z010 Manual

Product: