671447
89
Zoom out
Zoom in
Previous page
1/98
Next page
Maintenance and Troubleshooting 6 - 7
Expansion Backs
Stylus
Table 6-4 Troubleshooting the Expansion Backs
Symptom Possible Cause Solution
Aiming laser
does not display
when pressing
trigger.
On 8” tablet, did not
remove rubber gasket
during installation.
See system administrator to re-install Expansion Back.
ET5X is in suspend
mode.
Press power button to wake the tablet.
Battery is low. If the scanner stops emitting a laser beam upon a scan button
press, check the battery level. When the battery is low, the
scanner shuts off before the ET5X low battery condition
notification. Note: If the scanner is still not reading bar codes,
contact system administrator.
Laser comes on,
but scanner
does not decode
the bar code.
ET5X is not
programmed for the bar
code.
Ensure the application is programmed to read the type of bar
code being scanned. Contact system administrator.
Unreadable bar code. Check the symbol to ensure it is not defaced. Try scanning
another bar code of the same type.
Distance between exit
window and bar code is
incorrect.
Move the ET5X within proper scanning range.
Scanning application is
not loaded.
Load a scanning application. See the system administrator.
Table 6-5 Troubleshooting the Active Stylus
Symptom Possible Cause Solution
The stylus does
not write on the
ET5X.
Stylus is not activated. Tap or apply pressure to the tip of the stylus to activate it.
Stylus battery is installed
corrected or is depleted.
Replace the battery, making sure that you install it with the correct
polarity.
Calibration is incorrect. Recalibrate the pressure sensor.
Application is not active. Check that the application on the screen is selected and active.
The stylus has
short battery life.
The stylus tip my be
engaged when not in
use,
Be sure to store the stylus flat with no pressure applied to the tip.
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zebra ET5X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zebra ET5X in the language / languages: English as an attachment in your email.

The manual is 26,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zebra ET5X

Zebra ET5X Quick start guide - German - 26 pages

Zebra ET5X Quick start guide - French - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info