41
ENGLISH
10. Interrupting a programme
Depress INICIO / PAUSA button to interrupt a
running programme, the corresponding light will
begin flashing. Press this button again to re-start the
programme.
11. Opening the door after the
programme has started
Firstly, stop the machine by pressing
INICIO / PAUSA button.
After about two or three minutes the door can be
opened.
If the door does not open , this means that the
temperature of the water is too high, that the water
level exceed the lower limit of the door (which could
cause overflowing) or that the drum is spinning.
If the door cannot be opened but you need to open it,
switch the machine off by turning the selector dial to
“O”. After approximately two or three minutes the
door can be opened. (PAY ATTENTION TO THE
WATER LEVEL AND TEMPERATURE!)
12. At the end of the programme
The machine stops automatically.
Release of the lock is indicated when FIN light
comes on.
Turn the programme selector dial to position “O” to
switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty.
If you do not intend to put in another wash, turn off
the water tap. Leave the door open to prevent from
forming mildew and unpleasant smells.
ATTENTION!
If the RINSE HOLD option has been selected,
the last rinse water does not drain. To drain the
water, carry out the following steps:
1. Turn the programme selector dial to “
O”.
2. Select DRAIN or SPIN programme.
If programme (SPIN) has been selected:
Use the spin speed selector dial to choose the
required speed. If the dial is kept in the same
position as at the beginning, in other words
RINSE HOLD (no-wrinkle) position, the machine
will spin at 400 r.p.m.
3. Press INICIO / PAUSA button
7. OPTIONAL! Select, if required,
“8H/4H INICIO RETARDADO”
option button
Push “8H/4H INICIO RETARDADO” button as many
times as necessary until the corresponding light to
the required delay (8 H, 4 H) comes on.
8. Start the machine
Before starting the machine check that:
• the appliance is plugged in.
• the water supply tap is turned on.
• the drain hose is correctly and securely positioned.
• the door and the detergent dispenser drawer are
closed.
To start the selected programme, push
INICIO / PAUSA button; the corresponding light will
stop flashing and will remain lit until the end of the
programme.
If “8H/4H INICIO RETARDADO” option has been
chosen, the machine will begin the countdown.
9. Modification of a running
washing programme
Once the programme has started, it only can be
modified by turning the programme selector dial to
“O” and afterwards the new programme can be
chosen.
The washing water remains in the tub, provided that
the machine does not reach the rinse phase, since,
in this case, the machine drains it automatically.
Start the new programme by pressing
INICIO / PAUSA button.
