765778
27
Zoom out
Zoom in
Previous page
1/32
Next page
Problem Possible solution
The spin phase does
not operate or the
washing cycle lasts lon-
ger than usual.
Set the spin programme.
This problem may be caused by the clogged drain circuit. Please con-
tact the Authorised Service Centre.
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
There is water on the
floor.
Make sure that the couplings of the water hoses are tight and there is
not water leakages.
Make sure that the water inlet hose and the drain hose have no dam-
ages.
Make sure you use the correct detergent and the correct quantity of it.
You cannot open the
appliance door.
Make sure that a washing programme that ends with water in tub, has
not been selected.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
Make sure that the appliance receives electrical power.
This problem may be caused by a failure of the appliance. Contact the
Authorised Service Centre.
The appliance makes an
unusual noise and vi-
brates.
Make sure the levelling of the appliance is correct. Refer to "Installa-
tion instruction".
Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation instruction".
Add more laundry in the drum. The load may be too small.
The programme dura-
tion increases or de-
creases during pro-
gramme execution.
The AutoAdjust System is able to adjust the programme duration ac-
cording to the type and the laundry load size. Refer to "The AutoAdjust
System load detection" in "Daily Use" chapter.
The washing results are
not satisfactory.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash
the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Too much foam in the
drum during the wash-
ing cycle.
Reduce the quantity of detergent.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
Make sure that the flap is in the correct position (UP for powder deter-
gent - DOWN for liquid detergent).
Make sure you have used the detergent dispenser according the indi-
cations given in this user manual.
After the check, activate the appliance. The programme continues from the point
of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
27
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZWF144A2DG at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZWF144A2DG in the language / languages: English as an attachment in your email.

The manual is 1,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info