671312

Zanussi ZWF 9147BW Manual

13
Zoom out
Zoom in
Previous page
1/40
Next page
STARTING A PROGRAMME WITHOUT THE
FINISH AT OPTION
Touch the button .
• The indicator of the button stops to
flash and stays on.
• The programme starts, the door locks, the
indicator is on.
• The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
STARTING A PROGRAMME WITH THE
FINISH AT OPTION
Check if the appliance has the correct hour set.
See in "Clock setting" how to set the appliances's
clock.
First set the programme (and add options) then set
the option .
1. Touch the button to set the desired end
time. With the first touch the time is rounded to
the nearest hour or to the nearest half an hour.
By each next touch the end time increases by
30 minutes segments until maximum range of
20 hours.
1)
The display shows the finish hour you set (e.g.
) and the indicator is on to show that
this option is active.
2. Touch the button :
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically and the
actual programme duration counts down in
minutes until the cycle end.
You can cancel or change the set of
the option before you touch the
button . After touching the button
you can only cancel the option .
To cancel the Finish At option:
a. Touch the button
to set the appliance
to pause. The indicator of button
flashes.
b. Touch the button again and again until
the indicator goes off from the display.
Touch the button again to start the
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options.
If you change any option the option (if set)
will be disabled.
3. Touch again.
The programme continues.
CANCELLING A PROGRAMME
1. Press the button for some seconds to
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR
While a programme (or the ) operates, the
appliance door is locked. The indicator is on.
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
To open the door during the first minutes of
the cycle (or when the operates) :
1. Touch the button
to pause the appliance.
2. Wait until the indicator goes off.
3. You can open the door.
1) If you keep the button
pressed the digits change in a quicker way.
13
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZWF 9147BW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZWF 9147BW in the language / languages: English, German as an attachment in your email.

The manual is 1,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info