649510
15
Zoom out
Zoom in
Previous page
1/24
Next page
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the
End pilot light blinks to indicate that the ma-
chine is not working:
1 flash: problem with the water supply.
2 flashes: problem with the water draining.
4 flashes: door open.
Once the problem has been eliminated, press
the button START to restart the programme. If
after all checks, the problem persists, contact
your local Service Centre.
Problem Possible cause/Solution
The machine does not start:
The door has not been closed.
Close the door firmly.
The plug is not properly inserted in the power socket.
Insert the plug into the power socket.
There is no power at the socket.
Please check your domestic electrical installation.
The main fuse has blown.
Replace the fuse.
The selector dial is not correctly positioned and the button Start has not
been pressed.
Please turn the selector dial and press the button Start again.
The delay start has been selected.
If the laundry are to be washed immediately, cancel the delay start.
The machine does not fill:
The water tap is closed.
Open the water tap.
The inlet hose is squashed or kinked.
Check the inlet hose connection.
The filter in the inlet hose is blocked.
Clean the water inlet hose filter.
The door is not properly closed.
Close the door firmly.
The machine fills then emp-
ties immediately:
The end of the drain hose is too low.
Refer to relevant paragraph in «Installation» chapter.
The machine does not empty
and/or does not spin:
The drain hose is squashed or kinked.
Check the drain hose connection.
An option or a programme that ends with the water still in the tub or that
eliminates all the spinning phases has been selected.
Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
Redistribute the laundry.
15
www.zanussi.com
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZWC1301 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZWC1301 in the language / languages: English as an attachment in your email.

The manual is 2,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info