447684

Zanussi ZRT 724X Manual

19
Zoom out
Zoom in
Previous page
1/52
Next page
Defrosting the freezer
A certain amount of frost will always form on the
freezer shelves and around the top compartment.
Important! Defrost the freezer when the frost layer reaches
a thickness of about 3-5 mm.
To remove the frost, do these steps:
1. Switch off the appliance.
2. Remove any stored food, wrap it in several layers of
newspaper and put it in a cool place.
3. Leave the door open.
4. When defrosting is completed, dry the interior thor-
oughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain the maximum
coldness and run the appliance for two or three
hours using this setting.
7. Reload the previously removed food into the com-
partment.
Important! Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it. Do not use a
mechanical device or any artificial means to speed up the
thawing process other than those recommended by the
manufacturer. A temperature rise of the frozen food packs,
during defrosting, may shorten their safe storage life.
Periods of non-operation
When the appliance is not in use for long periods, take the
following precautions:
• disconnect the appliance from electricity supply
• remove all food
•
defrost
10)
and clean the appliance and all accessories
• leave the door/doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it
once in a while to prevent the food inside from spoiling in
case of a power failure.
What to do if…
Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Problem Possible cause Solution
The appliance is noisy The appliance is not supported prop-
erly
Check if the appliance stands stable (all
the four feet should be on the floor)
The appliance does not operate.
The lamp does not operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected to the
mains socket correctly.
Connect the mains plug to the mains
socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
10) If foreseen.
19
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZRT 724X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZRT 724X in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info