766304
13
Zoom out
Zoom in
Previous page
1/16
Next page
Problem Possible cause Solution
The lamp is defective. Contact the nearest Author-
ized Service Centre.
There is too much frost and
ice.
The door is not closed correct-
ly.
Refer to "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to "Closing the door"
section.
Food products are not wrap-
ped properly.
Wrap the food products better.
Temperature is set incorrectly. Refer to "Control Panel" chap-
ter.
Appliance is fully loaded and is
set to the lowest temperature.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Water flows on the rear plate
of the refrigerator.
During the automatic defrost-
ing process, frost melts on the
rear plate.
This is correct.
There is too much condensed
water on the rear wall of the re-
frigerator.
Door was opened too fre-
quently.
Open the door only when nec-
essary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrapped. Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Water flows inside the refriger-
ator.
Food products prevent the wa-
ter from flowing into the water
collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clogged. Clean the water outlet.
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The "FastCool function" is
switched on.
Switch off "FastCool function"
manually, or wait until the func-
tion deactivates automatically
to set the temperature. Refer
to "FastCool function" section.
The temperature in the appli-
ance is too low/too high.
The temperature is not set cor-
rectly.
Set a higher/lower tempera-
ture.
13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZRDN18FS1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZRDN18FS1 in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info