447667

Zanussi ZRB 324WO1 Manual

9
Zoom out
Zoom in
Previous page
1/30
Next page
9
GB
If something does not work
During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information is
given about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes with
certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation
We draw it to your attention again that the
appliance operates discontinuously, so the stopping
of compressor does not mean being no- current. That
is why you must not touch the electrical parts of the
appliance before breaking the circuit.
Problem Possible cause Solution
It is too warm in the
refrigerator
Thermostatic control can be set wrongly.
If products are not cold enough or placed wrong.
The door does not close tightly or it is not shut
properly.
Set the thermostat knob to higher position.
Place the products to the appropriate place.
Check if the door closes well and the gasket is
unhurt and clean.
It is too warm in the
freezer
Thermostatic control can be set wrongly.
The door does not close tightly or it is not shut
properly.
Products in big quantity to be frozen were put in.
Products to be frozen are placed too closely to
each other.
Set the thermostat knob to higher position.
Check if the door closes well and the gasket is
unhurt and clean.
Wait some hours and then check the
temperature again.
Place the products in a way so that cold air could
circulate among them.
Water flows at the back
plate of the refrigerator
Water flows into the
chamber
Water flows onto the
floor
It is normal. During automatic defrosting
frost melts on the back plate.
The outlet of the chamber can be clogged up.
Products placed in can prevent water from
flowing into the collector.
The melting water outlet flows not into the
evaporative tray above the compressor.
Clean the outlet.
Replace the products so that they can not touch
the back plate directly.
Put the melting water outlet to the evaporative
tray.
There are too much
frost and ice.
Products are not wrapped properly.
Doors are not shut properly or do not close tight.
The thermostatic control can be set wrongly.
Wrap the products better
Check if the doors close well and the gaskets are
unhurt and clean.
Set the thermostat knob to a position that gives
higher temperature.
The compressor
operates continually.
The thermostatic control is set wrongly.
Doors are not shut properly or do not close tight.
Products in big quantity to be frozen were put in.
Set the thermostat knob to a position that gives
higher temperature.
Check if the doors close well and the gaskets are
unhurt and clean.
Wait some hours and then check the temperature
again.
Put food at max. room temperature.
The a ppliance does
not work at all.
Neither cooling, nor
lighting works.
Indicator lamps do not
give light.
Too warm food was put in.
The appliance is in too warm place.
Plug is not connected to the mains socket
proper.
The fuse burnt out.
The thermostatic control is not on.
Try to reduce the temperature in the room where
the appliance stands.
Connect the mains plug properly.
Change the fuse.
Start the appliance according to instructions in
chapter “Putting it into use”.
Call an electrician.
The a ppliance is noisy.
There is no voltage in the mains socket.
(Try to connect another appliance into it.)
The appliance is not supported properly.
Check if the appliance stands stable (all the four
feet should be on the floor).
In as much the advice does not lead to result, call the nearest brand- mark service.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZRB 324WO1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZRB 324WO1 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info