76893

Zanussi ZOB 8900 X Manual

6
Zoom out
Zoom in
Previous page
1/40
Next page
Cleaning should be carried out when the appliance is COOL AND
SWITCHED OFF AT THE MAINS SUPPLY. Always clean off
spillage as quickly as possible to prevent burning on which will
make removal more difficult. Wash with a clean cloth soaked in
hot soapy water, rinse and dry with a soft cloth. Do not use
abrasives, caustic pastes or sprays, coarse cleaning pads or
powders. Do not use excessive water when cleaning your oven in
order to avoid water passing through clefts into the back of controls
panel or of the unit.
Do not use steam cleaners to clean the oven.
The oven accessories (shelve, grid, oven shelf carriers) and the
oven door also, can be removed for easier washing, to be done
with a mild detergent solution. The slots in the front of the appliance
for the passage of the air must carefully kept un-obtructed for an
efficient cooling of the unit.
Oven door removal and refitting
Open fully the oven door and hook the ring A to the upper bar of
the door hinge as shown in the fig. 6. Once hinge locked, grip both
sides of the door, near the hinges, then lift and remove as in the
fig. 7. After cleaning refit the oven door inversely proceeding in
similar way. Make sure the lower bars of the hinges correctely
placed in the proper slots and the rings A released from the upper
bars before closing the door.
Oven bulb replacement
Switch off your oven and isolate the power. When the oven is cool,
reach the light glass cover and unscrew it as shown in fig. 8.
Replace the bulb with a new one with the same specifications and
screw the cover back until is hand tight. Bulb replacement is not
covered by your Guarantee.
A
Fig. 6
Fig. 7
Fig. 8
Fig. 10
Before calling the service be sure you know how to operate your
oven: it may help you in explaining the malfunction to the serviceman
and check that there is not a power cut (with the fuse still working).
When you call for service or order parts do not forget to give:
model of your oven
serial number
colour (when in enamelled version)
part name or/and description of the problem
your full name, address, home phone number, (or/and business
phone number if appropriate).
The appliance must be installed by a qualified techician accordingly
with the instructions of this booklet and with the installation
requirements and regulations in force in the user's Country.
The oven must be installed in a housing which has been built to
withstand a temperature of 120 ° C in accordance with EEC REGS.
The manufacturer declines any responsa-bility for faults
arising from incorrect installation or/and connection or/and
inadequate ventilation.
Electrical connection
The installer will be responsable for complying with the safety
regulations of the user's Country.
Warning:
This appliance MUST be earthed.
The connection must be made directly to the mains supply by
installing between the supply mains and the appliance a double
pole.
The power supply must be fitted with a disconnect switch in which
the distance between contacts permits total disconnection in
accordance with overvoltage category III, as required by installation
regulations.
This appliance must not be connected integrally with any appliance
on the same sub-circuit.
Be sure that:
earth wire is not interrupted by the switch.
easy access to the switch is ensured once the appliance is
installed
the supply cable not comes in contact with any component the
temperature of which exceed 50 °C and with sufficient length
for allowing any subsequent removal of the unit.
once connected the appliance is working correctely.
Important
The housing should not be free standing, but secured to the wall
or/and adjacent fittings and housing, do not lift it by the door
handle. Do not force the oven into the housing using the open
door as a lev and never exercise excessive pressure on the open
door. The oven should be secured to the housing by nº 4 fitting
screws in holes of the frame as shown in fig. 10.
Servicing information
Instructions to the installer
ENGLISH
Cleaning and maintenance
6
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZOB 8900 X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZOB 8900 X in the language / languages: English, German, Dutch, French, Portuguese as an attachment in your email.

The manual is 3,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info