Manual Zanussi ZHT 910 (page 17 of 44) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

447511

Zoom out

Zoom in

1/44

USE - MAINTENANCE

3 - OPERATION

3.1- Controls are located on the right hand side of the front to operate worktop illumination and select the

most suitable working speed for your cooking. To increase the area of extraction, the glass visor should

be pulled open. The top speed should be used when frying or cooking foods with strong odours, while a

lower speed can be used for normal cooking. To obtain the best performance from your hood, turn it on

before you start cooking and leave it running for a few minutes after your cooking is over to clear the air.

3.2- Pay attention to safety regulations 1.7 and 1.8.

4 - MAINTENANCE AND CLEANING

Regular maintenance and cleaning will ensure good performance and reliability, while extending the

working-life of the hood. Special attention should be reserved to the grease filter and to the charcoal fil-

ter (recycling mode).

4.1 - Grease filter

This retains the solid grease particles and can be supplied in different types. lt is fitted onto the reverse

side of the metal grille panel. Maintenance of the grease filter varies according to the used type.

a-Whatever type of filters used, the filter is easily removed from the grille by pushing the metal wire clips

to one side and removing.

b-Thin synthetic filter (1 mm thick). It should not be washed and should be replaced every two months. If

the filter is provided with a saturation indicator, replace when:

b.1-The violet colour of the dots, which are visible through the metal grille, is spread over the whole

surface of the filter.

b.2-The red colour of the stripes, which is not visible through the metal grille when the filter is clean,

becomes visible from the outside of the metal grille.

c-Multi-layer metal filter. It should be washed once a month in hot water using mild detergent or liquid

soap. It can be washed in a dish-washer. It should not be bent and should be left to drain dry.

WARNING: An excess of grease in the filter not only would affect the performance of the hood, but it is

also a possible fire risk. We strongly recommend therefore to clean and replace filters in accordance

with the manufacturer instructions.

4.2 - Cleaning Metal self- supporting Grease Filters

• The filters are washable and must be cleaned at least every 2 months of operation, or more

frequently for particularly heavy usage.

• Remove the filters one at a time by pushing them towards the back of the group and pulling down at

the same time.

• Wash the filters, taking care not to bend them. Allow them to dry before refitting.

• When refitting the filters, make sure that the handle is visible on the outside.

4.3 - Charcoal filter

The charcoal filter is a chemical filter to be used only when the hood is in the recycling position. To re-

place the charcoal filter, open the grille and remove the thumb screw through the centre of the charcoal

filter. If the filter is of the interlocking type, turn the filter anticlockwise. Replace by reversing the opera-

tion. For a good performance replace the charcoal filter on average every three months.

4.4 - Worktop illumination

If a lamp fails to function at any time, open the metal grille panel and check that the lamp is fully

screwed into the holder. When changing the lamp, an identical replacement must be fitted to ensure a

safe working of the hood.

4.5 - Cleaning

The metal work should be cleaned regularly, at least once a month, using mild household cleaner and

polish. Never use abrasives. For all operations from point 4.1 to point 4.4 and in particular for point 4.3,

pay special attention to the safety regulation 1.9.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZHT 910 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 0,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zanussi ZHT 910 Manual

Product: