447512
13
Zoom out
Zoom in
Previous page
1/44
Next page
13
Part 1 - INSTALLATION INSTRUCTIONS
2.4 - Choice of operating mode
a)Evacuation mode
To check that the hood is set up for evacuation, open
the grille panel and make sure that the conversion lever
or the change-over knob on the centrifugal unit is in
the DUCTING position (B). The charcoal filter is not
required. For ducting to the outside, the hood is
supplied with a rear and top outlet. A flange spigot of
100 mm diameter (120 mm in certain models) is usually
fitted on the top outlet and a blanking plug on the rear
outlet. If you choose to duct the hood from the rear of
the casing, you should invert the position of the flange
and of the blanking plug. Pay attention to the safety
regulation 1.1.
b)Internal recirculation mode
To check that the hood is set up for recycling, open
the grille panel and make sure that the conversion lever
or the change-over knob on the centrifugal unit is in
the RECYCLING position (A). The charcoal filter is to
be fitted. To fit the charcoal filter, support the filter with
one hand and turn the thumb screw through the centre
of the charcoal filter. If the filter is of the interlocking
type, turn the filter clockwise. The hood can remain
connected to the outside.
2.5 - Electrical connection and
working test
1 - The safety measures 1.2, 1.3, 1.4 and 1.5
of paragraph 1 are to be strictly observed.
2 - Once the electrical connection has been
completed, check that the worktop
illumination, motor and speeds work
properly.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZHT 658 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZHT 658 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info