74482

Zanussi ZGL 64 ITX Manual

30
Zoom out
Zoom in
Previous page
1/48
Next page
30
Operation
Hob burner control knobs
The symbols on the knobs mean:
z = no gas supply
= maximum gas supply
= minimum gas supply
For easier lighting, proceed before
putting a pan on the pan support.
Lighting the burners
• To light a burner, push the electric
ignition pushbutton which is marked
by a little spark ( );
• at the same time turn the relevant
control knob anticlockwise to
maximum position ( );
• after lighting the flame, keep the
knob pushed down for about 5
seconds. This will allow the
"thermocouple" to be heated and
the safety device to be switched off,
otherwise the gas supply would be
interrupted;
• then, check the flame is regular and
adjust it as required.
If you cannot light the flame even after
several attempts,check the "cap" and
“crown” (seeFig.1- lett. A, B) are in the
correct position.
In the absence of electricity, ignition
can occur without the electrical device;
in this case approach the burner with a
flame, push the relevant knob down and
turn it anti-clockwise until it reaches the
"maximum" position.
To switch off burners
To put the flame out, turn the knob to
the symbol (z).
Take care when frying food in hot
oil or fat, as the overheated
splashes could easily ignite.
When switching on the mains,
after installation or a power cut, it is
quite normal for the spark
generator to be activated
automatically.
Always turn the flame down or
put it out before taking the pans
off the burner.
Do not keep the control knob
pressed for more than 15 seconds.
If the burner does not light even
after 15 seconds, release the
control knob, turn it the “off”
position and wait for at least one
minute before trying to light the
burner again.
If the burner accidentally goes out,
turn the control knob to the “off”
position and wait for at least 1
minute before trying to light the
burner again.
)
)
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple
Fig. 1
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZGL 64 ITX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZGL 64 ITX in the language / languages: English, Dutch as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info