447476
13
Zoom out
Zoom in
Previous page
1/60
Next page
damage to property caused by failure to obey these re-
quirements.
To prevent the risks of structural damage or physical
injury, installation, connection of the appliance to the
power supply and gas system, setting up and mainte-
nance must only be done by qualified personnel in
compliance with standards and local regulation force.
Make sure that the appliance is not damaged because
of transport. Do not connect a damaged appliance. If it
is necessary, speak to the supplier.
Only use built-in appliances after you assemble the ap-
pliance into correct built-in units and work surfaces
that obey the standards.
Do not install the hob over a domestic appliances if the
installation instructions do not allow it.
Install the appliance only on a worktop with flat sur-
face.
Do not change the specifications or modify this prod-
uct. There is the risk of injury and damage to the appli-
ance.
Fully obey the laws, ordinances, directives and stand-
ards in force in the country where you use the appli-
ance (safety regulations, recycling regulations, electri-
cal safety rules etc.)
Keep the minimum distances to other appliances and
units.
Install anti-shock protection, for example install the
drawers only with a protective panel directly below the
appliance.
Prevent damage of the cut surfaces of the worktop
against moisture with a correct sealant.
Seal the appliance to the worktop with no space left
with a correct sealant.
Prevent damage to the bottom of the appliance from
steam and moisture, e.g. from a dishwasher or oven.
Do not install the appliance adjacent to doors and be-
low windows. Hot cookware can be hit off the hob
when you open the doors or windows.
Before installation, make sure that the local supply
conditions (gas type and pressure) agree with the ad-
justment of appliance. The adjustment conditions for
the appliance are on the rating plate, which you can
find near the gas supply pipe.
This appliance is not connected to a combustion prod-
ucts evacuation device. It must be installed and con-
nected in accordance with current installation regula-
tions. Particular attention must be given to the relevant
requirements regarding ventilation.
The use of a gas cooking appliance cause heat and
moisture in the room in which it is installed. Make sure
that the ventilation in the kitchen is good: keep natural
ventilation holes open or install a mechanical ventila-
tion device (mechanical extractor hood).
More ventilation (for example opening of a window or
increasing the level of mechanical ventilation where
present) is necessary when you operate the appliance
with intensity for a long time.
Carefully obey the instructions for electrical connec-
tions. There is the risk of injury from electrical current.
Disconnect the appliance from the electrical supply,
before you do the maintenance work or you clean it.
The electrical mains terminal is live.
Make electrical mains terminal free of voltage.
Install correctly to give anti-shock protection.
A loose and incorrect mains plug and socket connec-
tions can make the terminal become too hot.
A qualified electrician must install the clamping con-
nections correctly.
Use a strain relief clamp on cable.
Use the correct mains connection cable and replace the
damaged mains cable with applicable cable. Speak to
your local Service Force Centre.
The appliance must have the electrical installation
which lets you disconnect the appliance from the
mains at all poles with a contact opening width of min-
imum 3 mm.
If the fixing bracket is near to the terminal block, al-
ways make sure the connection cable does not come in
contact with the edge of the bracket.
You must have correct isolation devices: line protect-
ing cut-outs, fuses (screw type fuses removed from the
holder), ground leakage trips and contactors.
Disposal of the appliance
To prevent the risk of physical injury or damage
Disconnect the appliance from the power supply.
Cut off the mains cable where it connects with the
appliance and discard it.
Flat the external gas pipes if there are fitted.
Speak to your local authorised facilities for disposal
of your appliance.
13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZGL 63IT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZGL 63IT in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info